When deploying a Cisco HyperFlex edge with a pair of switches, what is the minimum number of interfaces in trunk mode required on each HX node?
What is the benefit of adding Cisco HyperFlex Hardware Acceleration Cards to a HyperFlex deployment?
An engineer must Configure a new Cisco UCS B-Series infrastructure with a Cisco 5108 chassis. The configuration must meet these
requirements:
• The setup must use aggregation between Cisco UCS Fabric Interconnects and I/O modules.
• The implementation requires four 10 GbE connections per I/O module.
• The Cisco UCS Fabric Interconnects must support uplinks of different speeds for future expansion.
Which two steps must be taken to meet these requirements? (Choose two.)
Refer to the exhibit.
An engineer must configure FCoE with these requirements:
• VLAN 100 must be used to carry the Ethernet traffic.
• Fabric A must use FCoE on VLAN 11 and VSAN11.
• Fabric B must use FCoE on VLAN 12 and VSAN 12.
• vfc 10 on Fabric A must be bound to Ethernet 1/1 on N5K_1.
• vfc 11 on Fabric B must be bound to Ethernet 1/1 on N5K_2.
Which interface vfc 10 configuration accomplishes these requirements?
A)
B)
C)