Scenario:
Please read this scenario prior to answering the question
Your role is that of a consultant to the Lead Enterprise Architect in a company that develops wind turbines for use in wind farms. The company has three manufacturing facilities, one in North America, one in Asia, and one in Europe. Each of these facilities supplies the power industry in its region.
The company recognizes that the long-term technical potential of wind energy can address the current global dependency on carbon fuels. In order to do so this will require wind turbines to be installed over large areas of higher wild resources. In particular, offshore wind farms can contribute substantially more energy than land stationed trubines.
The research arm of the company has pioneered the development of an offshore wind turbine design, with an improved turbine blade and power system that will produce up to 20% more energy. This will allow the production of significantly more saleable energy. This new design is ready to go into production.
The company has a mature Enterprise Architecture organization that is supported by a cross-functional Architecture Board and uses the TOGAF standard. The Chief Information Officer and the Chief Operating Officer co-sponsor the Enterprise Architecture program.
Recently, a pilot architecture project was completed at a single location that defined a standard approach for controlling the Automated Test System that is used at each plant to perform final quality assurance tests on each completed blade assembly. The Architecture Board approved the plan for immediate implementation at each plant.
Architecture Contracts have been developed that detail the work needed to implement and deploy the new Automated Test System controller for each location. The Chief Engineer, sponsor of the activity, has expressed concern that a uniform process be employed at each location to ensure consistency.
Refer to the Scenario
You have been asked to recommend the best approach to address the Chief Engineer's concern.
Based on TOGAF 9, which of the following is the best answer?
Which of the following best describes a purpose of the Gap Analysis technique?
According to TOGAF, which of the following activities is described as part of the approach in the Preliminary Phase of the ADM?
Which of the following is described by the TOGAF Architecture Content Framework as a type of artifact that shows relationships between things?
Which of the following best describes the concept of Boundaryless Information Flow?
Which one of the following does TOGAF state is an objective for Phase A: Architecture Vision?
Consider the following statements describing the TOGAF ADM
1. All ADM activities are carried out within an iterative cycle of continuous architecture definition and realization
2. The Requirements Management phase is a continuous phase
3. Output from an early phase may be modified in a later phase
4. When a phase starts, the previous phase closes
Which statements are correct?
According to TOGAF, how is the Enterprise Continuum used in organizing and developing an architecture?
TESTED 22 Feb 2025
