Load balancing implements the function of distributing user traffic accessing the same IP address to different servers. What are the main technologies used?
An intranet has made a network, the old equipment is offline, the new network equipment is brought online, and after the service test, it is found that most of the original service traffic cannot work normally. What is the quickest way to restore the business?
Comparing URPF strict mode and loose mode, which of the following statements is incorrect?
About load balancing, the following configuration is available: [USG] slb enable [USG]slb [USG-slb] rserver 1 rip 10.1.1.3 weight 32 [USG-slb] rserver 2 rip 10.1.1.4 weight 16 [USG-slb] rserver 3 rip 10.1.1.5 weight 32 [USG-slb] group test [USG-slb-group-test]metric srchash [USG-slb-group-test] add rserver 1 [USG-slb-group-test] add rserver 2 [ USG-slb-group-test] add rserver 3 Which of the following statements is correct?
A user wants to limit the maximum bandwidth of the 192.168.1.0/24 network segment to 500M, and limit all IP addresses in the network segment to maintain a bandwidth of 1M. How should I configure a current limiting policy for this requirement?
In the IPSec VPN, the digital certificate is used for identity authentication. If the IKE main mode is used for negotiation, the certificate verification is completed in message 5 and message 6.
The preemption function of the VGMP management group is enabled by default, and the delay time is 60s.
The dual-system hot backup load balancing service interface works at Layer 3, and the upstream and downstream routers are connected to each other. The two USG devices are active and standby. Therefore, both the hrp track master and the hrp track slave must be configured on the morning service interface.
TESTED 22 Feb 2025
