Exactprep 156-836 Questions

Dual Orchestrators work as an Active-Active cluster, which means that both Orchestrators are active and share the load of the traffic that is sent to and from the Security Group Members (SGMs). Active-Active cluster provides better performance and scalability than Active-Standby cluster, which only uses one Orchestrator at a time and keeps the other as a backup. Active-Active cluster also allows for faster failover and recovery in case of an Orchestrator failure, as the surviving Orchestrator can take over the traffic without interruption.

References

•Maestro Expert (CCME) Course - Check Point Software, page 25

•CheckPoint Certified Maestro Expert (CCME) - Skillzcafe, page 2

•Check Point Certified Maestro Expert (CCME) R81.X - Global Knowledge, page 2

The lldpctl command is a tool to display information about the devices discovered by the Link Layer Discovery Protocol (LLDP) on all ports of the Maestro Orchestrator and the Security Group Members. LLDP is a protocol that enables devices to exchange information about their identity, capabilities, and configuration. LLDP can help to discover the topology and connectivity of the Maestro environment. The output of lldpctl can show the serial number, appliance model, and orchestrator’s IP of the connected devices, but it cannot show the distribution mode of the Security Group. The distribution mode is the algorithm that determines how the Maestro Orchestrator distributes the traffic among the Security Group Members. To view the distribution mode, other commands such as asg monitor or asg stat can be used.

References

•Check Point Certified Maestro Expert (CCME) R81.X Courseware, Module 4: Using the Command Line Interface and WebUI, Lesson 4.2: LLDP, page 4-9

•Check Point R81 Maestro Administration Guide, Chapter 3: Working with Security Group Modules, Section: LLDP, page 3-9

•Check Point R81 Maestro Administration Guide, Chapter 2: Maestro Security Groups, Section: Traffic Distribution, page 2-7

•Maestro basic setup documentation - Page 2 - Check Point CheckMates

•Log and Configuration Files - Check Point Software

The asg_perf_hogs command is a script that displays the processes that are consuming excessive system resources, such as CPU, memory, disk, and network, on the orchestrator and the appliances. It can help identify performance issues and bottlenecks in the Maestro environment.

References

•Software Provision and Performance hogs failed - Check Point CheckMates1

•CHECK POINT MAESTRO EXPERT, page 33

The cpinfo command is a tool that collects diagnostic information about the orchestrator, such as hardware, software, network, configuration, and logs. The cpinfo command generates a file that can be sent to Check Point Support for analysis and troubleshooting. The cpinfo command can be run on the orchestrator’s CLI or WebUI.

References =

•Check Point Maestro R81.X Administration Guide, page 68, section “cpinfo” 1

•Check Point Maestro R81.X Getting Started Guide, page 30, section “cpinfo” 2

•Maestro Hyperscale Orchestrator Datasheet - Check Point Software 3

1: https://www.manualslib.com/manual/2031661/Check-Point-Maestro-R80-20sp.html 2: https://sc1.checkpoint.com/documents/R81/WebAdminGuides/EN/CP_R81_Maestro_GettingStarted/html_frameset.htm 3: https://www.checkpoint.com/downloads/products/maestro-hyperscale-orchestrator-datasheet.pdf