The MHO (Maestro Hyperscale Orchestrator) does not require a license by itself, but each SGM (Security Group Module) that is attached to the MHO needs a license. The license type depends on the features and blades that are enabled on the SGM. For example, if the SGM is running VSX, it needs a VSX license.
References:
•Maestro Expert (CCME) Course - Check Point Software, page 71
•Check Point Certified Maestro Expert (CCME) R81.X - Global Knowledge, course outline
Question 21
Is it possible to define distribution mode per interface?
Options:
A.
Yes, only for downlink interfaces
B.
No, only for the Security Group
C.
Yes, only for uplink interfaces
D.
Yes, for both uplink and downlink interfaces
Answer:
D
Explanation:
Explanation:
Maestro allows you to define the distribution mode per interface, which determines how traffic is distributed among the Security Group Modules (SGMs) in a Security Group. You can configure the distribution mode for each interface individually, or use the default mode for all interfaces. The distribution mode can be set for both uplink and downlink interfaces.
What command can be run to show which SGM is selected to receive traffic?
Options:
A.
g_tcpdump
B.
asg monitor
C.
dxl calc
D.
asg calc
Answer:
D
Explanation:
Explanation:
The asg calc command is a tool to show which SGM is selected to receive traffic based on the distribution mode and the packet parameters. It takes the port number, the source IP, the destination IP, and optionally the source port and the destination port as arguments and returns the SGM ID and the hash value. For example, asg calc 1 10.0.0.1 20.0.0.2 1234 80 will show which SGM will receive the traffic from 10.0.0.1:1234 to 20.0.0.2:80 on port 1.
References
•Check Point Certified Maestro Expert (CCME) R81.X Courseware, Module 4: Using theCommand Line Interface and WebUI, Lesson 4.1: asg calc, page 4-5
•Check Point R81 Maestro Administration Guide, Chapter 4: Using the Command Line Interface and WebUI, Section: asg calc, page 4-5