What can be learned from the output of sx_api_ports_dump.py command?
Options:
A.
Information about backplane bonds
B.
Information about Security Groups
C.
Orchestrator port status
D.
Information about downlink ports only
Answer:
A
Explanation:
Explanation:
References
•R81.20 Maestro Cheat Sheet version 7 - Check Point CheckMates, page 2
•[Maestro Expert (CCME) Course - Check Point Software], page 31
•[Check Point Certified Maestro Expert (CCME) R81.X - Global Knowledge], page 3
Question 17
What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?
Options:
A.
1Gbps connectivity for Security Groups
B.
Reserved for internal purposes. Not in use.
C.
Out-of-band interfaces for access to Orchestrator itself
D.
Additional ports used as uplinks
Answer:
C
Explanation:
Explanation:
The Management ports located on the Rear Panel of the Orchestrator MHO-140 are out-of-band interfaces that provide access to the Orchestrator itself for configuration and management purposes. They are not used for traffic distribution or connectivity to the Security Groups or the external networks. They are 1Gbps RJ-45 ports that can be connected to a switch or a router.
References
•Maestro Hyperscale Orchestrator Datasheet - Check Point Software1, page 2
•Quantum Maestro Getting Started Guide - Check Point CheckMates2, page 4
Question 18
Splitter cannot be used _______
Options:
A.
To connect single port on orchestrator to the same Appliance
B.
To connect single port on orchestrator to multiple port on external switch
C.
To connect single port on Appliance to multiple ports on the orchestrator
D.
To connect single port on orchestrator to multiple Appliances
Answer:
A
Question 19
What is the purpose of g_tcpdump command?
Options:
A.
Collects traffic dump from all Active Appliances within Security Group
B.
Collects traffic dump from CIN network
C.
Collects traffic dump from Sync network
D.
The same as tcpdump, just on Scalable Platform
Answer:
A
Explanation:
Explanation:
_tcpdump" probably collects traffic dumps from all active appliances within a security group, aligning with the naming convention and function of similar commands in scalable platforms.
References
•Maestro Expert (CCME) Course - Check Point Software, page 331
•What is ‘IN’ and ‘OUT’ of g_tcpdump? - Check Point CheckMates2