CWDP-304 Exam Dumps - CWNP Certification Questions and Answers

Free space path loss causes greater signal dispersion for higher rate transmissions.

Receiver sensitivity requirements are lower for frames transmitted with less complex modulation and coding.

To improve reliability, 802.11 STAs increase transmit power as the signaling rate decreases.

Lower data rate RF transmissions travel at higher speeds and are less likely to experience collisions.

The signal affects the entire spectrum and will render the wireless network unusable. It must be located and removed.

The signal has a low duty cycle and should not be of major impact on the wireless network.

The signal is alternating between peaks (high interference level) and valleys (low interference level). The network channel design must be

built to avoid the affected peak frequencies.

The signal is typical of a high radio card background noise. It shows that the card used for the Layer 1 sweep should be replaced and the

Layer 1 sweep re-

17 dBm

125 mW

11 dBm

6.25 mW

Throughput rates above 50 Mbps

Data rates above 100 Mbps

Latency

PoE provided to wireless handsets