CWDP-304 Exam Dumps - CWNP Certification Questions and Answers

Move one or more APs so that indoor propagation results in coverage in that area or install another AP on that side of the elevator shaft

Turn up the power on the three APs closes! to that area

Install antennas with at least 3 more dB of gain on the two APs closest to that area

Replace all the clients in that area with clients having better receive sensitivity

The result was that APs were above and below each other on the same channel, resulting in excessive CCI The APs should have been deployed so that they were not directly above and below each other and so that they used varying channels between floors

The result was that clients could only connect to APs on their floor and, in a multi-floor deployment, you want clients to connect to APs on other floors in case they roam between floors.

The result was that AC) was increased because the APs were deployed above and below each other on the same channels.

The result was that the frequency utilization was too low for the clients to capture RF waves on which to transmit their signals.

Redesign the entire WLAN

Quickly add more APs

Upgrade the Ethernet connections to MultiGig

Turn up the output power on the APs so that they can handle more clients

Reconfigure the network to use static channel plans because automatic channel assignment algorithms are all broken

Purchase and deploy new APs from a different vendor

Reconfigure the automatic channel assignment settings to use only channels 1, 6, and 11

Leave it as it is; sometimes using all 11 channels in 2.4 GHz gives the optimum performance result

Ensure that the output power of all APs is set to the maximum allowed in the regulatory domain

Ensure that the output power of an APs is set to the minimum available in the system interface

Replace all antennas with panel antennas instead of omnidirectional antennas

Configure the settings used by the dynamic channel assignment algorithm optimally for your design

Real Time FFT means Real Time First Fundamental Trace and shows the value of the first signal detected on each frequency at each sweep

interval.

Real Time FFT means Real Time Fast Frequency Timing and shows the RF pulses measured by the Layer 1 sweep tool.

Real Time FFT means Real Time Fast Fourier Transform and shows the max value of the signal detected on each frequency in real time.

Real Time FFT means Real Time Frequency Fundamental Texture and shows the value of the noise background generated by the card used

to perform the

Real Time FFT means Real Time Fast Fourier Transform and shows the max value of the signal detected on each frequency in real time.

CAPWAP and GRE

LWAPP and FTP

SSL and SSH

TLS and SSL

Add more APs to the infrastructure

Increase the transmit power on all APs

Turn-off 2.4 GHz radios on some APs

Use all channels available in the 2.4 GHz band

handheld scanner

tablet

laptop

USB 2.0 adapter

mobile phone

Integration

Data

Distribution

Control

Management