300-510 Exam Dumps - Cisco CCNP Service Provider Questions and Answers

Router 1 centrally learns the topology of the network to aid in SR-TE path selection, and Router 2 is a node that feeds Router 1 topology information.

Router 1 and Router 2 are participating in SR-TE tunnels and are both head-end routers.

Router 1 and Router 2 centrally learn the topology of the network to aid in SR-TE path selection for peers.

Router 2 is the head-end router in an SR-TE tunnel, and it is learning topology of the network from the PCE enabled on Router 1.

It limits the number of routes a device receives from its peers, which reduces CPU load.

It improves service by increasing the number of simultaneous iBGP peering sessions.

It redirects traffic away from route reflectors, which reduces their operating load.

It reduces the number of iBGP peers and increases stability.

Sequences are added after implementing a route map, but routing policies must be reconfigured when change is needed.

Route maps are implemented using hierarchical policies, but routing policies must be implemented sequentially.

Route maps require an explicit deny at the end of the sequence, but routing policies have an implicit deny at the end of the program.

Route policies require sequence numbers, but route maps are implemented without sequencing.

Route maps are supported in Cisco 10S Software and routing policies are supported in Cisco IOS XR Software.

IS-IS and OSPF use area packets, but only IS-IS uses sequence number packets.

IS-IS and OSPF use link-state update packets, but only OSPF uses link-state ACK packets.

IS-IS and OSPF use Hello packets, but only OSPF uses DBD packets.

IS-IS and OSPF use link-state update packets, but only IS-IS uses DBD packets.

It is implemented without excessive processing power.

It supports IPv4 and IPv6 traffic on the same infrastructure.

It allows an engineer to stack multiple Layer 2 switches to serve as a single switching unit.

It requires tunneling IPv6 traffic over an IPv4 infrastructure.

It securely routes and tunnels traffic between separate sites over the Internet.

Option A

Option B

Option C

Option D

Router ID 10.1.5.5 is not reachable from R2

OSPF authentication has failed between R2 and 10.1.5.5

It is an expected behavior when OSPF network type is broadcast

OSPF parameters (Area ID or hello interval) are mismatched between R2 and 10.1.5.5

Remove the allocate-labels command.

Reconfigure the route-policy ALL_LABELS to match all after the drop.

Reconfigure the route-policy ALL_LABELS to pass.

Remove the route policy and only configure "allocate-label".