HPE6-A72 Exam Dumps - HP Aruba Certified Switching Associate (ACSA) V1 Questions and Answers

Question # 24

Refer to the exhibit.

What is the correct binary conversion of the last two hexadecimal characters of the physical address?

Options:

1101 1000

1110 1101

1001 1111 0101 0011

1000 1101 1110 1101

Buy Now

Question # 25

Refer to the exhibit

What is true regarding VLAN 50 according to the diagram above?

Options:

VLAN 50 is part of a switched virtual interface (SVI) that was never routed causing it to be down.

Since VLAN 50 has not been assigned to any enabled physical port, the status is down.

VLAN 50 is assigned only to Trunk ports which is why no ports are listed under interfaces.

VLAN 50 was never added to the vlan-database and therefore is in a down state.

Buy Now

Question # 26

Refer to the exhibit.

What does the command page result in?

Options:

Starts an automatic page scrolling effect that pauses for a few seconds every 30 rows.

Enables a terminal notification when a new debug event occurs for L2MAC events.

Shows a new terminal window opening to allow typing while debugging occurs.

Results in a page break to disable the default continuous scrolling In the console.

Buy Now

Question # 27

ServiceOS login:admin

SVOS>password

Enter password:********

Confirm password:********

The login password to access an Aruba AOS-CX was lost. After connecting to the switch console port, a reboot is performed and the Service OS console is accessed as shown above.

What is the default password that is required for the admin account while under the Service OS console?

Options:

No password is set for this account.

"password"

"forgetme!"

The same login password that has lost originally.

Buy Now

Question # 28

Refer to the exhibit.

What command will display the debug l2mac events?

Options:

show module L2MAC

show debug terminal

show debug buffer module L2MAC

show debug all

Buy Now

Question # 29

Refer to the exhibit.

All switches shown are CX 6300M. The links connecting SW3 to both SW1 and SW2 are broken. Multi-Active Detection has not been enabled. What are two results? (Select two.)

Options:

A re-election will occur upon repairing the disabled links between SW2 and SW3. The switch with the highest priority will reclaim the Master role with the lowest bridge mac-address acting the tie-breaker

The OSPF adjacency between the OSPF neighbor and the VSF stack switches SW2 and SW3 will remain up. Packets destined for SW3 that are received on SW2 are discarded.

The stack will split with SW1 remaining an active VSF Master and SW3 becoming another active VSF Master. Switch 2 will remain a VSF member switch.

Only the OSPF adjacency between SW3 and the OSPF neighbor will fail. All routed traffic will be redirected to SW2 instead.

The stack will split resulting in SW1 remaining an active VSF Master and SW3 disabling all ports. SW2 will automatically take the VSF Standby role.

Buy Now

Question # 30

Match each network protocol to the correct default listening port and transport protocol. Not all answers will be used.

Options:

Buy Now

Question # 31

What is the binary conversion of the hexadecimal value 0x2001?

Options:

0010 0001

0002 0000 0000 0001

0011 0000 0000 0001

0010 0000 0000 0001

Buy Now

Question # 32

What is true about VSX? (Choose two.)

Options:

VSX is ideal for Campus access layer deployments where ease of deployment is needed.

VSX allows upgrading members with near zero downtime or loss of packets.

VSX is available on all Aruba OS-CX switches except the 6300F model.

VSX is implemented on static port switches. VSX-plus needed to stack chassis together.

VSX run separate control planes to reduce latency and improve performance.

Buy Now

Question # 33

Place the OSI Layers in the correct order. Arrange them from least to greatest, starting with Layer 1 on the top, and progressing to Layer 7 on the bottom.