HPE6-A72 Exam Dumps - HP Aruba Certified Switching Associate (ACSA) V1 Questions and Answers

VPN access

WAN/MPLS connectivity

Endpoint Access

Deep packet inspection

Power over Ethernet

Access-1(config)# interface 1/1/1

Access-1(config-if)# routing

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

Access-1(config)# interface 1/1/1

Access-1(config-if)# vlan trunk permit vlan 100

Access-1(config-if)# interface vlan 100

Access-1(config-if-vlan)# ip address static 10.1.1.1/24

Access-1(config)# interface vlan 100

Access-1(config-if-vlan)# ip address 10.1.1.1/24

Access-1(config-if)# vlan 100

Access-1(config-vlan)# ip address 10.1.1.1/24

switch(config-if)# no lldp interface (port) transmit

switch(config-if)# no lldp transmit

switch(config-if)# no lldp receive

switch(config)# no lldp

a discovery protocol used between Layer 3 devices to determine routes within a single autonomous system

a standardized IPv6 neighbor discovery protocol used to replace the ARP and broadcast mechanism used in IPv4

a standardized protocol for communicating directly-connected device information and capabilities.

an Aruba proprietary discovery protocol supported in all Aruba switches along with Cisco Discovery Protocol or CDP

Manually disable the redundant link to immediately resolve the impacted portion of the network.

Utilize Spanning Tree to dynamically disable all redundant links in a segment.

Setting switch ports to half-duplex will resolve Broadcast storms using Carrier Sense Multiple-Access Collision Detection (CSMA/CD).

Enable single Area Open Shortest Path First (OSPF) on all Layer 2 switches, but do not enable routing.

Utilize Spanning Tree to dynamically block Designated ports in addition to Alternate ports.

a machine learning method of packet inspection for the purpose of choosing which dynamic routing protocol to automatically assign

a concept that applies to firewalls, when examining packets only up through Layer 4

a function of Policy Based Routing that examines the entire IPv4 header to forward traffic based on factors other than destination address

a firewall process of examining the packet header all the way to Layer 7 in order to determine if the packet should be permitted or denied

MST region type

MST Bridge ID

MST version number

MST revision number

MST VLAN to instance mapping

The command will fail because rollback commands must be issued from global-config mode.

The switch will revert the running-configuration to the checkpoint called 'start1without a reboot.

The command will fail because it is incomplete.

The switch will use the checkpoint 'rollback1as the starting configuration on next reboot.