New Year Special 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: Board70

Passed Exam Today 350-501

Page: 31 / 33
Question 124

Refer to the exhibit:

Which statement describes this configuration?

Options:

A.

Router 1 has its running configuration locked so changes can be made only when the administrator issues a kill session

B.

Router 1 can be remotely managed by the CLI using Telnet

C.

Router 1 has a new data store to collect SNMP information, but configuration must still be done at the CLI only

D.

Router 1 has a temporary data store where a copy of the running configuration can be manipulated and verified before committing the configuration

Question 125

What is a characteristic of data modeling language?

Options:

A.

It provides an interface for state data.

B.

It separates configuration and state data.

C.

It ensures devices are individually configured.

D.

It replaces SNMP.

Question 126

Refer to me exhibit.

Refer to the exhibit. A network engineer notices PE-21 convergence degradation due to the growing LSDB size of Level 2 areas in the network. The engineer decides to migrate router PE-21 from an inter-area design to an intra-area implementation. Inter-area routing must be accomplished via an ATT-bit set by the Level 1/Level 2 router. Which configuration must the engineer implement on PE-21 to complete the migration?

Options:

A.

configure terminal

router isis 1

no net 49.0200

net 49.5000

is-type level-1-2

end

B.

configure terminal

router isis 1

net 49.5000.0100.1202.0021.00

is-type level-1-2

end

C.

configure terminal

router isis 1

net 49.5000.0100.1222.0022.00

is-type level-1

end

D.

configure terminal

router isis 1

no net 49.0200.0100.1202.0021.00

net 49.5000.0100.1202.0021.00

is-type level-1

end

Question 127

Refer to the exhibit. A network engineer received a complaint about these problems in OSPF stub area 100:

  • The Ethernet link is down between routers RX and RY because the fiber was cut.
  • CE site A traffic to the hub site is being dropped.

Which action resolves these issues?

Options:

A.

Set the OSPF authentication type to MD5 between RX and RY DUMPS

B.

Change the OSPF area 100 type to stub on RZ.

C.

Change the OSPF priority to 100 on the interfaces that connect RX and RY.

D.

DUMPS Set the OSPF MTU to 1500 on the link between RX and RZ.

Page: 31 / 33
Exam Code: 350-501
Exam Name: Implementing and Operating Cisco Service Provider Network Core Technologies (350-501 SPCOR)
Last Update: Dec 23, 2024
Questions: 452
350-501 pdf

350-501 PDF

$28.5  $94.99
350-501 Engine

350-501 Testing Engine

$33  $109.99
350-501 PDF + Engine

350-501 PDF + Testing Engine

$43.5  $144.99