CCNP Service Provider 350-501 Updated Exam

Page: 6 / 33

Question 24

An engineer working for a private service provider with employee id: 3994 37 650 is configuring a Cisco device to redistribute OSPF into BGP. Which task enables the device to filter routes?

Options:

Configure a distribute list and associate it to the BGP peer interface

Configure a prefix list and associate it to the BGP peer interface

Configure a route map and reference it with the redistribute command

Configure an access list and reference it with the redistribute command

Question 25

Which condition must be met for TI-LFA to protect LDP traffic?

Options:

For single-segment protection, the PQ node must be LDP and SR-capable.

The protected destination must have an associated LDP label and prefix-SID.

The point of local repair must be LDP-capable.

For double-segment protection, the P and Q nodes must be SR-capable.

Question 26

Refer to the exhibit. A network administrator implemented MPLS routing between routers R1, R2, R3, and R4. AToM is configured between R1 and R4 to allow Layer 2 traffic from hosts on RA1 and RA2. A targeted MPLS session is established between R1 and R4. Which additional action must the administrator take on all routers so that LDP synchronization occurs between connected LDP sessions?

Options:

Disable the MPLS LDP IGP sync holddown.

Configure OSPF or IS-IS as the routing protocol.

Configure EIGRP as the routing protocol using stub areas only.

Enable MPLS LDP sync delay timers.

Question 27

Refer to the exhibit. A service provider engineer Is configuring the connection between CE1 and CE2. AS 200 of the service provider and AS 100 of enterprise ABC should connect using BGP. The engineer already completed the configuration of VRF RT 100:10 of enterprise ABC. Which configuration must the engineer apply on PE1 to meet the requirement?