350-501 VCE Exam Download

The issue is that router R2 is not installing the network 172.16.33.1/32 in the routing table due to an incorrect access list configuration. The correct answer is option C, which will allow the network to be installed in the routing table by permitting addresses from 172.16.33.0 to 172.16.33.255 with a wildcard mask of 0.0.0.255.

The current access list on R2, “access-list 1 permit 172,16,32,0 0,0,0,255”, only permits addresses from the range of 172,16,32,0 to 172,16,32,255 due to its wildcard mask of “0,.0,.0,.255”. This does not include the address “172,.16,.33,.1”.

References: Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) study guide or course materials available on Cisco’s official website or authorized training partners.

When configuring the 802.1q VLAN tag, the MTU must be increased by 4 bytes. This is because the 802.1Q tag adds an additional header to the Ethernet frame, which includes information such as the VLAN ID and priority. To accommodate this extra header without fragmenting the packet, the MTU must be increased accordingly2. References: Configure 802.1Q VLAN Tagging, 802.1q and MTU.

MPLS TE FRR (Fast ReRoute) provides backup protection by creating a bypass LSP for each protected LSP at each point of local repair. This method allows for rapid switching to the backup path in case of a failure, minimizing traffic loss and disruption.

References :=

• Implementing and Operating Cisco Service Provider Network Core Technologies (SPCOR) course materials.