Last Attempt JN0-637 Questions

Use an external router.

Use an interconnect VPLS switch.

Use a secure wire.

Use a point-to-point logical tunnel.

The target-host parameter should be used instead of the any-remote-host parameter.

The port-overloading parameter needs to be turned off in the NAT source interface configuration

The target-host-port parameter should be used instead of the any-remote-host parameter

The any-remote-host parameter does not support interface-based NAT and needs an IP pod to work.

Both the internal and the external host can initiate a session after the initial translation.

Only a specific host can initiate a session to the reflexive address after the initial session.

Any external host will be able to initiate a session to the reflexive address.

The original destination port is used for the source port for the session.

IKE is not an allowed protocol in the external interfaces' security zone.

IKE is not an allowed protocol in the tunnel endpoints' security zone.

OSPF is not an allowed protocol in the tunnel endpoints' security zone.

BGP is not an allowed protocol in the tunnel endpoints' security zone.