Ericsson Certified Associate ECP-206 Reddit Questions

Referring to the exhibit, the correct statement is that the service provider’s P routers are not aware of the customers’ routes. This is because P routers only need to forward MPLS packets based on their labels, without looking into their IP headers or VPN information. The P routers do not have any VRFs configured for the customers, nor do they participate in MP-BGP sessions with other PE routers. The PE routers are responsible for maintaining VRFs for each customer and for exchanging VPN routes with other PE routers using MP-BGP910.

References: Layer 3 VPNs (L3VPN) - Cisco, MPLS VPN - Wikipedia

A P router is a provider router that is part of the service provider’s core network in an MPLS environment. A P router does not have any customer routes or VPN information, but only has information about how to reach other P routers and PE routers in the same MPLS domain. A P router performs label switching, which means that it forwards labeled packets based on their top label in the label stack. A P router can perform two possible label actions:

• Swap: The P router replaces the incoming label with a new label that corresponds to the next hop along the label-switched path (LSP). The new label is determined by looking up the label forwarding information base (LFIB) based on the incoming label and interface.
• PHP: The P router removes the top label from the packet at the penultimate hop before reaching the egress PE router. This is done to avoid an extra lookup on the egress PE router, which can forward the packet based on its IP header or another label in the stack.

A P router does not perform push or drop actions on labels. A push action means adding one or more labels to the packet, which is done by an ingress PE router when initiating an LSP. A drop action means discarding a packet, which is done by any router when there is no matching entry in its LFIB or routing table. References: Provider (P) Router in IP MPLS Network - Cisco Community, MPLS Fundamentals: Forwarding Labeled Packets - Cisco Press, MPLS Label Switching | MPLS Operation | Push, Swap,Push ⋆ IPCisco

The statement about IPv6 that is correct is that broadcast has been replaced with multicast. IPv6 is the most recent version of Internet Protocol (IP), which provides an identification and location system for computers on networks and routes traffic across the Internet. IPv6 has several improvements over IPv4, such as a larger address space, simplified header format, enhanced security, and better support for mobility and QoS.One of the changes in IPv6 is that it does not support broadcast, which is a method of sending a packet to all nodes on a network segment. Instead, IPv6 uses multicast, which is a method of sending a packet to a group of nodes that have joined a multicast address34.

References: IPv6 - Wikipedia, What Is IPv6? - Cisco