4A0-101 Exam Dumps - Nokia SRC Certification Questions and Answers

From the least significant 32 bits of the chassis MAC address.

From the most significant 32 bits of the chassis MAC address.

From the loopback IP address.

By using the command "config router router-id X.X.X.X"

From the system IP address.

From the highest interface IP address.

IPv6 uses the Address Resolution Protocol to resolve the address to a MAC address.

A Neighbor Discovery message is sent to the broadcast MAC address. The host with the IPv6 address responds with a Neighbor Advertisement message.

A Neighbor Discovery message is sent to the solicited-node multicast address. The host with the IPv6 address responds with a Neighbor Advertisement message.

A Neighbor Discovery message is sent to the anycast address for the LAN. The host with the IPv6 address responds with a Neighbor Advertisement message.

IPv6 addresses do not need to be resolved to a MAC address.

193.45 32 0/20

193.45.0.0/21

192.45.32.0/21

192.45.0.0/20

Link Local LSA

Router LSA

Network LSA

Inter-Area Router LSA

Intra-Area Prefix LSA

None of the above LSAs have an AS scope.

R1 has one IS-IS adjacency and one LSP.

R1 has one IS-IS adjacency and two LSPs.

R1 has one IS-IS adjacency and four LSPs.

R1 has two IS-IS-adjacencies and two LSPs

R1 has two IS-IS adjacencies and four LSPs

Black hole

Default gateway

Gateway path

Proxy ARP

A Type 4 LSA is originated by an ABR to describe a route to an ASBR to routers outside the area.

A Type 4 LSA is originated by an ASBR to describe a route to itself to routers outside the area.

A Type 4 LSA is originated by an ABR that is connected to a stub area. The LSA is injected into the backbone area to provide routing information.

A Type 4 LSA is originated by an ABR that is connected to a stub area. The LSA is injected into the stub area to provide routing information.

Router R1 generates a Type 4 LSA that is flooded to areas 0, 1, and 2.

Router R3 generates a Type 4 LSA that is flooded to areas 0, 1, and 2.

Router R3 generates a Type 4 LSA that is flooded to areas 0 and 2.

Router R3 generates a Type 4 LSA that is flooded to area 0, and router R6 generates a Type 4 LSA that is flooded to area 2.

The area addresses TLV

The intermediate system neighbors TLV

The IP interface address TLV

The authentication information TLV

Metric is based on hop count.

Slow convergence after link failures.

Support hierarchy through the use of areas.

Support for CIDR.

Link state updates sent using layer 3 multicast.