Exhibit:
VDX11# show vcs detail
Config Mode : Distributed
VCS ID : 10
Total Number of Nodes : 3
Node :1
Serial Number : BWW2535G00E
Condition : Good
Status : Co-ordinator
VCS Id : 10
Rbridge-Id : 10
Co-ordinator : YES
WWN : 10:00:00:05:33:91:3D:F4
Switch MAC : 00:05:33:91:3D:F4
FCF MAC : 0C:B3:1E:F8:0C:B3
Internal IP : 127.1.0.10
Management IP : 10.255.248.24
Exhibit:
Referring to the exhibit, in which mode of operation is the active switch participating?
When congestion is experienced in a network, which type of frame is transmitted when protocol 802.3x flow control is enabled?
You are using VxLANs to extend your L2 domains over your L3 networks.
What is added to the VxLAN to do this?
A Brocade VCS Fabric is running NOS 4.1.1 on two Brocade VDX 8770s and four Brocade VDX 6740s in logical chassis mode. You are required to deploy FCoE servers and Layer 3 features in the solution.
Which two licenses are required? (Choose two.)
In the exhibit, both MAC addresses are assigned to interface 2/0/4.
What does the (UC) indicate?
During a network outage, several RBridges in VCS Logical Chassis mode were disconnected from the rest of the network. During this time, some configuration changes were made to those switches.
When the network connection between the separated switches is repaired, what will occur?
To form a Brocade VCS Fabric between a Brocade VDX 6730 and a VDX 6740T, what is required?
A Brocade VDX 6730 is added to an existing three node Brocade VCS Fabric running NOS 4.1. You want to manage all switches in the fabric from the principal switch.
What should you do to accomplish this task?
You are using PBR in your Brocade VCS Fabric and you would like to selectively modify and route the IP packets in the hardware.
Which two would you configure? (Choose two.)
You are planning the integration of a new Brocade VCS Fabric into your legacy spanning tree environment.
In which two scenarios would configuring STP be appropriate? (Choose two.)
TESTED 22 Feb 2025
