Refer to the exhibit.
A backup policy uses a Full backup schedule with a schedule type of Frequency: 1 days. The start window for the schedule is configured as shown in the exhibit:
The administrator runs a manual backup at 10:00 on Thursday.
When will the next backup run, if all prior backups completed successfully?
An administrator observes intermittent connectivity issues between the appliance and clients.
Which NetBackup Appliance Shell Menu (CLISH) command can the administrator use to assist in diagnosing the problem?
Which command can an administrator run to test and analyze connections between master servers, media servers, and clients for multiple NetBackup ports?
A NetBackup master server has commenced writing four long-running duplication jobs to an AdvancedDisk disk pool. The value of “Maximum concurrent jobs” for the storage unit and “Limit I/O streams” for the disk pool are both set to 4.
There are 35 jobs queued on the master server that require this disk pool:
5 replication jobs with priority 9999
10 backup jobs with priority 999
20 duplication jobs with priority 99
Two restore jobs that require this disk pool are then submitted with default priority.
Which job type goes active next?
How can an administrator view the bpbrm log files on an appliance using the NetBackup Appliance Shell Menu (CLISH) interface?
An administrator is attempting to protect 500TB of Windows file system data in a 4-hour backup window, when the file servers are idle. The daily change rate for the data is below 1%, and an Initial full backup has been performed to a high performance disk array configured as an Advanced Disk storage unit.
What can the administrator do to ensure subsequent backups complete within the backup window?
Where in the NetBackup Administration Console should an administrator look to determine whether an AdvancedDisk storage server is configured?
What is the primary purpose of implementing load balancing media servers with NetBackup appliances?
An administrator is adding a new media server appliance to an existing NetBackup appliance master server.
What is the correct sequence to configure the new appliance in the NetBackup domain?
A tape library had the robot firmware upgraded, and now the robot is reading the barcodes with additional characters.
How should an administrator enable NetBackup to use the same characters that were used before the firmware upgrade?
TESTED 22 Feb 2025
