NSE7_SDW-7.2 Exam Dumps - Fortinet Certification Questions and Answers

Destination internet service must be enabled on the traffic shaping policy.

Application control must be enabled on the firewall policy.

Web filtering must be enabled on the firewall policy.

Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.

After FortiGate switches to active mode, FortiGate never fails back to passive monitoring.

During passive monitoring, FortiGate can’t detect dead members.

FortiGate can offload the traffic that is subject to passive monitoring to hardware.

FortiGate passively monitors the member if TCP traffic is passing through the member.

VPN monitor tool provides additional statistics for tunnels defined with an IPsec recommended template.

FortiManager automatically installs IPsec tunnels to every spoke when they are added to the FortiManager ADOM.

IPsec recommended template guides the administrator to use Fortinet recommended settings.

IPsec recommended template ensures consistent settings between phase1 and phase2

Traffic has matched none of the FortiGate policy routes.

Matched traffic failed RPF and was caught by the rule.

The FIB lookup resolved interface was the SD-WAN interface.

An absolute SD-WAN rule was defined and matched traffic.

The number of simultaneous connections among all source IP addresses cannot exceed five connections.

The traffic shaper limits the combined bandwidth of all connections to a maximum of 5 MB/sec.

The number of simultaneous connections allowed for each source IP address cannot exceed five connections.

The traffic shaper limits the bandwidth of each source IP address to a maximum of 625 KB/sec.

You can reference meta fields.

You can configure interfaces as SD-WAN members without having to remove references first.

You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.

You can configure advanced CLI settings.

FortiGate performed standard FIB routing on the session.

FortiGate will not re-evaluate the session following a firewall policy change.

FortiGate used192.2.0.1as the gateway for the original direction of the traffic.

FortiGate must re-evaluate the session due to routing change.

You can assign only one template with a tunnel of fype static to each FortiGate device

You can define only one IPsec tunnel from branch devices to HUB1.

You can assign only one IPsec template to each FortiGate device.

You should review the branch1_fgt configuration for the already configured tunnel with the name HUB1-VPN2.

update-source

set-route-tag

holdtime-timer

link-down-failover

Packet duplication can leverage multiple IPsec overlays for sending additional data.

Packet duplication does not require a route to the destination.

Packet duplication supports hardware offloading.

Packet duplication uses smaller parity packets which results in less bandwidth consumption.