An administrator is supporting a network with the access layer consisting of AOS-CX 6300 and 6400 switches. The administrator needs to quickly deploy Aruba IAPs and security cameras in the network, ensuring that the correct QoS and VLAN settings are dynamically applied to the switch ports. Currently, switches are not configured to do device authentication, and no authentication server exists in the network.
Which AOS-CX feature should the administrator use to dynamically assign the policy settings to the correct switch ports?
How does PIM build the IP multicast routing table to route traffic between a multicast source and one or more receivers?
An administrator is implementing a multi-area OSPF network. The network contains a backbone (area 0) and two other areas (1 and 2) connected to ABRs in the backbone The network has one routing switch connected to a service provider located in area 2 Which network design would minimize the number of routes in the routing switches' link state databases (LSDBs) while still allowing full connectivity?
An administrator is looking for a data center switching solution that will greatly reduce the likelihood of dropped
frames when uplink congestion is experienced. Which AOS-CX switch queuing feature meets the
administrator’s needs?
Examine the following AOS-CX switch configuration:
Which access control entries would allow web traffic to the web servers 10.1.0.100 and 10.1.1.100?
A company has recently upgraded their campus switching infrastructure with AOS-CX switches. They have
implemented 802.1X authentication on access ports where laptop and IOT devices typically connect. An
administrator has noticed that for POE devices, the AOS-CX switch ports are delivering the maximum wattage
to the port instead of what the device actually needs.
Concerned about this waste of electricity, what should the administrator implement to solve this problem?
What is correct regarding the tunneling of user traffic between AOS-CX switches and Aruba Mobility
Controllers (MCs)?
Examine the following AOS-CX switch configuration:
Which statement correctly describes what is allowed for traffic entering interface 1/1/3?
A network has an ABR that connects area 0 and 1. A network engineer configures a summarized route for area 0. The ABR is a designated router (DR) for the segment it uses to connect to area 1.
Which LSA type is assigned to this route when the summarized route is advertised into area 1 by the ABR?
TESTED 22 Feb 2025
