H35-580_V2.0 Exam Dumps - Huawei Certification Questions and Answers

According to the Career Certification - Huawei Enterprise, single site verification is used to test and verify the equipment functions and coverage capability after gNodeB hardware is installed and commissioned, which corresponds to option C.

According to the HCIA-5G V2.0 Exam Outline, base station receive diversity gain is a factor that affects uplink coverage, not downlink coverage. Downlink coverage is affected by factors such as downlink path loss, downlink transmit power, and antenna gain, which correspond to options B, C, and D.

According to the HCIA-5G V2.0 Exam Outline, SS-RSRP is the reference signal received power of the synchronization signal block (SSB) in NR systems. It can be used for measurement evaluation in idle mode during coverage problem analysis, which corresponds to option D. OPMI is an indicator of uplink interference power measurement, CSI-RSRP is the reference signal received power of the channel state information reference signal (CSI-RS), and SRS is the sounding reference signal. These indicators are used for measurement evaluation in connected mode, not idle mode, which correspond to options A, B, and C.

According to the BBU Quick Installation Guide (V100R005C10_04) (PDF)-EN, the UPEU in the BBU5900 needs to be connected to only one circuit breaker, not two. The UPEU is a universal power and environment interface unit that provides power supply and environment monitoring functions for other boards in a subrack. The UPEU converts -48 V DC to +12 V DC and distributes the power to other boards. The UPEU also collects alarms from the subrack and reports them to the main processing board. The UPEU can be installed in slot 0 or slot 10 of the BBU5900 subrack. The UPEU needs to be connected to a -48 V DC power cable that is connected to a circuit breaker in the cabinet. The circuit breaker must have a rated current of 16 A or higher. Therefore, the correct answer is B.

According to the 5G NR Downlink CSI Reporting, CSI-RS is the channel/signal that is used by the UE to measure and obtain the CQI. CSI-RS stands for Channel State Information Reference Signal, which is a downlink reference signal transmitted by the gNodeB to enable the UE to estimate the channel quality and feedback the CQI to the gNodeB. The CQI is an indicator of how good or bad the channel quality is, and it can be used by the gNodeB to adjust the modulation and coding scheme for data transmission.

According to the HCIA-5G V2.0 Exam Outline, handover execution failures can use the counters to collect failure reasons in SA networking, which corresponds to option A. The counters include N.HO.Exec.Fail.RadioResFail, N.HO.Exec.Fail.TAExceed, N.HO.Exec.Fail.NoRespFromUE, and N.HO.Exec.Fail.Other.

According to the HCIA-5G V2.0 Exam Outline, no response from the UE, insufficient radio resources, and unauthorized UE are cause values of QoS flow setup failures, which correspond to options A, B, and D. Insufficient transmission resources is not a cause value of QoS flow setup failures, but a cause value of handover execution failures, which corresponds to option C.

Massive MIMO is a technology that uses a large number of antennas at the base station to serve multiple users simultaneously, thereby increasing the spectral efficiency and capacity of the wireless system 1. Massive MIMO is especially suitable for application scenarios where there is high user density and high traffic demand, such as large venues, high-rise buildings, and densely populated urban areas 2. Suburban areas with light traffic do not have such high requirements for spectral efficiency and capacity, and therefore are not a typical application scenario of massive MIMO.