H35-260 Exam Dumps - Huawei HCSA-Field-Transmission Questions and Answers

The default route is configured on the L2/3 master node, and the next-hop points to the L3 master node

A default route is configured on the L2/L3 standby node, and the next hop points to the L3 master node

On the L3 raw node, configure a default route with the next hop pointing to the main L2/L3 node

Configure the default route on the standby point, and the next hop points to the standby L2/L3 node

True

False

255.255.255.0

255.255.255.128

255.255.255.192

255.255.255.224

Overlap Mode

Cascading Mode

Nested Mode

Punch-Through Mode

Smartbits

SDH Analyzer

Spectrum analyzer

Bit Error Tester

After the hardware inspection of the single station is completed, make sure that all power switches are in the off position

It is strictly forbidden to plug and unplug the power plug and PIU single board while electrified

In the case of power failure, you can contact the board without wearing an anti-static wrist or anti-static gloves

If the input voltage of the equipment is not within the required range, a rectification suggestion should be put forward, and power-on is strictly

prohibited

It is composed of all L2 routers (including L1/L2)

can be discontinuous

For inter-area routing

Identify with area 0

OPUK

ODUK

OCH

OTUK

The Type field in the ETH header is set to 0x8847 to indicate that it is followed by MPLS label encapsulation

The nested encapsulation of MPLS can only be two layers, PW and Tunnel two layers of labels

The MPLS label of the Tunnel carrying the PW, where the S bit is set to 1

IP packets can be directly carried on the Tunnel

Client Official Report

External reporting

Engineer's Report

Internal Reporting