GET 65% Discount on All Products Coupon code: "bigdisc65"
When running FastIron SPS08095e code, which step is required to define static routes?
Change the ICX image version to SPR08095e.bin.
Install the L3-prem license.
Run the UFI code image for GZR08095h.
Upgrade to version SPS08095h or later.
To define static routes on a device running FastIron SPS08095e code, it's essential to have the appropriate licensing in place.
Understanding Licensing Requirements:
RUCKUS ICX switches require specific licenses to enable advanced features.
The "L3-prem" (Premium Layer 3) license unlocks advanced routing capabilities, including the ability to configure static routes.
Verifying Current License Status:
Access the switch's command-line interface (CLI).
Execute the command show license to display the current licensing status.
Check for the presence of the "L3-prem" license in the output.
Installing the L3-prem License:
If the "L3-prem" license is not installed, obtain it from RUCKUS Networks or an authorized distributor.
Follow the official RUCKUS licensing guide for detailed installation instructions.
Configuring Static Routes:
Once the "L3-prem" license is active, enter global configuration mode by typing configure terminal.
Use the ip route command to define static routes. For example: ip route [destination_network] [subnet_mask] [next_hop_ip].
After configuring, save the settings with the write memory command to ensure persistence across reboots.
References:
For detailed information on licensing and feature sets, refer to the FastIron 08.0.95 (GA) Software Licensing Guide.
TESTED 22 Jan 2025
