Passed Exam Today CTFL_Syll2018

A testing design technique based in the system requirements. Decision table testing is a black-box testing technique that is used to test complex business rules or logic that involve multiple conditions and actions. Decision table testing uses a tabular format to represent all possible combinations of inputs (conditions) and outputs (actions) for a given decision. Decision table testing helps to ensure that all scenarios are covered and tested. A detailed explanation of decision table testing can be found in A Study Guide to the ISTQB® Foundation Level 2018 Syllabus, pages 47-511.

Testing can demonstrate that there are defects in the software, by finding and reporting them. Testing cannot demonstrate that there are no defects, because it is impossible to test all possible scenarios and inputs. Testing cannot demonstrate that the software is correct, because correctness is a subjective and relative concept that depends on the expectations and requirements of the stakeholders. Testing cannot demonstrate that there are no hidden defects in the software, because hidden defects are those that are not detected by testing or other quality assurance activities.

The fundamental test process is a generic model that describes the main activities and tasks involved in testing. The fundamental test process consists of five phases: planning and control, analysis and design, implementation and execution, evaluation of exit criteria and reporting, and test closure activities. Implementation and execution is the phase where test cases and test procedures are implemented according to test specifications and executed on the system or component under test using test tools or manual methods. Implementation and execution also involves verifying that the test environment set up is correct, which means ensuring that the test environment (such as hardware, software, network, data, etc.) is ready and suitable for testing the system or component under test. A detailed explanation of implementation and execution can be found in [A Study Guide to the ISTQB® Foundation Level 2018 Syllabus], pages 19-21.

 S2 and O2 are the finishing state and the output(s) from the test case1. The question asks about a test case that starts at S1 and triggers 4 events in sequence: E1, E4, E5, E7. The question refers to a state diagram that shows the logic of a system with six states (S1, S2, S3, S4, S5, S6) and seven events (E1, E2, E3, E4, E5, E6, E7). The state diagram also shows four outputs (O1, O2, O3, O4) that are produced by some events. The state diagram is shown below:

!state diagram

To answer this question, we need to follow the path of the test case on the state diagram and observe the state transitions and outputs that occur. The path of the test case is:

• Start at S1
• Trigger E1
• Transition to S2
• Trigger E4
• Transition to S3
• Trigger E5
• Transition to S2
• Output O2
• Trigger E7
• Transition to S6

Therefore, the finishing state of the test case is S2 and the output(s) from the test case is O2. Hence, D is the correct answer.