Newly Released Cisco 300-425 Exam PDF

Page: 6 / 14

Question 24

How does AP failover priority for access points function when configured with priority 1 or 4?

Options:

When configured with priority 1, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

When configured with priority 4, the access point is assigned with the highest priority level and it is marked as critical. This access point fails over before other access points with the lower priority when there is primary controller failure.

When configured with priority 4, the access point is assigned with the lowest priority level and it is marked as low. This access point fails over after other access points with the higher priority when there is primary controller failure.

When configured with priority 1, the access point is assigned with the medium priority level and it is marked as medium. This access point fails over after other access points with the higher priority when there is primary controller failure.

Question 25

Refer to the exhibit.

What is the main reason why the Wi-Fi design engineer took a different approach than installing the APs in the offices, even though that installation provides better coverage?

Options:

aesthetics

transmit power considerations

antenna gain

power supply considerations

Question 26

A network engineer is configuring high availability on an access point. What is the maximum number of controllers that can be configured?

Options:

Question 27

A wireless network consists of:

• two IOS XE controllers installed in a data center

• 9100 series APs

• corporate and a guest WLAN

The customer must high availability pair two Cisco WLCs for the client SSO. Which two design approaches must the engineer take to meet the requirement? (Choose two.)