Last Attempt 300-615 Questions

Page: 3 / 6

Question 12

Refer to the exhibit.

A blade that is connected to FI-B fails to boot from a SAN LUN. The boot policy is configured to boot by using vHBA1 as the SAN Primary. Which set of actions resolves the issue?

Options:

• Set ESX01_B zone to VSAN 20.

• Create a new vHBA and assign VSAN 20.

• vHBA1 to VSAN 20 in Service Profile.

• VMware Adapter Policy on vHBA1.

•Apply VMware Adapter Policy on vHBA1

•Change vHBA1 to VSAN 20 in Service Profile

• Set ESX01_B zone to VSAN 20.

• Change vHBA1 to VSAN 20 in Service Profile

Question 13

A system administrator adds two vNICs to an existing service profile that is used to run a vSphere environment to support disjoint Layer 2 network connectivity. However, after the server is rebooted, the host is not accessible on the network Which action resolves the issue?

Options:

Remove all existing vNICs and add them in the desired order.

Build a new service profile with the desired network configuration

Add the disjoint Layer 2 VLANs to an existing vNIC rather than adding new vNICs

Create a vNIC placement policy to avoid adapter renumbering

Question 14

Refer to the exhibit.

The vPC neighborship between two switches is in suspended state. Which configuration change resolves the issue and brings up the vPC neighborship?

Options:

Change STP Port Type to Network on the peer switch

Enable Bridge Assurance on the local switches

Configure QoS MTU value of 9216 on the peer switch

Add VLAN 400-401 to the configuration on the local switch

Question 15

Refer to the exhibit.

An engineer fails to install Perl in the guest shell on a Cisco Nexus 9000 Series Switch. Which two actions must be taken in the guest shell to resolve the issue? (Choose two.)