Free Access Cisco 300-615 New Release

Page: 4 / 6

Question 16

Refer to the exhibit.

A network engineer is implementing a pair of Cisco Nexus 9000 Series Switches. During the OSPF configuration, the engineer discovers unstable routing in the network. The investigation shows flapping routes after the new switches were introduced. Which set of actions resolves the issue?

Options:

Configure a new IP address on the Ethernet interface toward the OSPF neighbor. Clear the OSPF neighbor.

Configure a new IP address on the Ethernet interface toward the OSPF neighbor. Clear the OSPF process.

Configure a new OSPF priority on the Ethernet interface toward the OSPF neighbor. Clear the OSPF neighbor.

Configure a new IP address on the Loopback interface for the OSPF process. Clear the OSPF process

Question 17

Refer to the exhibit.

The vPC between switch1 and switch2 does not work. Which two actions resolve the problem? (Choose two.)

Options:

Configure the IP address on the interface.

Activate VLANs on the vPC.

Configure one of the switches as primary for the vPC.

Correct the configuration of the vPC peer link and the vPC peer keepalive.

Match the vPC domain ID between the two devices.

Question 18

You have an ACI environment with three APICs, two spine switches, and four-leaf switches. You wipe and reboot all APICs first then leaf and spine switches one-by-one and successfully go through the Initial Setuo dialogue on the APIC 1 CIMC KVM console. When you log in to the APIC1 WebGUI, you notice that you do not see any directly connected leaf switches being discovered under Fabric > Inventory > Fabric Membership. What is the cause of the issue?

Options:

The leaf nodes were not erased properly, which caused a fabric parameters mismatch with the APIC1.

Rebooting the APICs and the leaf and spine switches after wiping them is not required.

You forgot to enter the TEP Pool value during the Initial Setup dialogue on APIC1.

The same Fabric Name value should be used before after wiping all devices.

Question 19

Refer to the exhibit.

An administrator directly connects a Fibre Channel storage array to ports 1 through 4 on a Cisco UCS 6454 Fabric Interconnect. The administrator configures a service profile to boot directly from the new Fibre Channel storage array, but the service profile fails to boot. When the administrator checks the output of the show flogi database command on the fabric interconnect, it shows the output presented in the exhibit. Which action resolves the issue?