Exactprep LEED-AP-BD+C Questions

Adding a concrete walkway will increase the site’s impervious cover, which is the percentage of the site area that does not allow water to infiltrate into the ground1. Impervious cover can affect the site’s stormwater management, heat island effect, and habitat quality. The project team should consider using permeable paving materials, vegetated roofs, or rain gardens to reduce the impervious cover and mitigate its impacts2. The other options are not directly impacted by adding a concrete walkway. Project density calculations are based on the floor area ratio and the number of occupants, not the site features3. Erosion and sediment control plan during construction is required for any site disturbance, regardless of the type of material used4. Air quality as a result of off gassing that occurs as concrete cures is not a significant issue for outdoor applications, and can be minimized by using low-emitting concrete products5.

The distance between the project site and the manufacturing location is determined by the straight line distance. This is because the LEED v4 Reference Guide for Building Design and Construction states that the distance should be measured as the crow flies1. The straight line distance is the shortest distance between two points on a plane, regardless of the mode of transportation or the road conditions. The image that you sent shows the straight line distance between the project site and the manufacturing location as the line segment AB.

References:

LEED v4 Reference Guide for Building Design and Construction, Materials and Resources Credit: Building Product Disclosure and Optimization - Sourcing of Raw Materials, page 551

The Materials and Resources Credit, Building Product Disclosure and Optimization, Material Ingredients, Option 2. Material Ingredient Optimization & Innovation Credit, Innovation, Exemplary Performance can be achieved if the total cost of permanently installed products are 25% cradle-to-cradle V3 Gold and 25% GreenScreen List Translator. This is because these certifications indicate that the materials used in the project have been assessed for their environmental and health impacts, contributing to the achievement of these credits.References: LEED AP Building Design + Construction (LEED AP BD+C) V4 resources 1

According to the LEED v4 Reference Guide for Building Design and Construction, the project team must conduct a waste stream audit to identify the top five recyclable waste streams generated by the building and its occupants. The audit must cover a representative time period of a minimum of 24 hours, and must account for variations in the type and quantity of waste generated by different building uses and operations. The project team must then provide dedicated areas for the collection and storage of these materials for recycling. The project team must also provide dedicated areas for the collection and storage of batteries, mercury-containing lamps, and electronic waste, or demonstrate that a local program is in place to properly dispose of these materials.

References:

LEED v4 Reference Guide for Building Design and Construction, Materials and Resources Prerequisite: Storage and Collection of Recyclables, page 5441

LEED v4 Credit Tutorials: Materials & Resources (BD+C/ID+C), Prerequisite: Storage and Collection of Recyclables2