CWDP-304 Exam Results

Page: 2 / 20

Question 8

If you choose to recommend dynamic channel assignment for the APs in your WLAN design what action should you also recommend'?

Options:

Ensure that the output power of all APs is set to the maximum allowed in the regulatory domain

Ensure that the output power of an APs is set to the minimum available in the system interface

Replace all antennas with panel antennas instead of omnidirectional antennas

Configure the settings used by the dynamic channel assignment algorithm optimally for your design

Question 9

While performing a validation site survey, you realize that overlapping channels are being used on the 2.4 GHz bad due to the automatic channel assignment algorithm of the WLAN infrastructure.

What should you do to prevent this?

Options:

Reconfigure the network to use static channel plans because automatic channel assignment algorithms are all broken

Purchase and deploy new APs from a different vendor

Reconfigure the automatic channel assignment settings to use only channels 1, 6, and 11

Leave it as it is; sometimes using all 11 channels in 2.4 GHz gives the optimum performance result

Question 10

In a convention center, you have received complaints about the WLAN infrastructure. At this moment, the are only two APs in one auditorium. After

analyzing the situation, you determined that there are more client devices that the infrastructure was designed for. There are only two APs to

support more than 300 devices using the Wi-Fi at the same time. What should you do to make the Wi-Fi work as expected?

Options:

Redesign the entire WLAN

Quickly add more APs

Upgrade the Ethernet connections to MultiGig

Turn up the output power on the APs so that they can handle more clients

Question 11

A designer has created a WLAN design that has been implemented in an organization. The network exists in a four-story building Because each floor has an Identical floor plan, the designer designed only one floor and had the installers duplicate the design on each floor. Now. in validation, it is not performing well What best explains the problem caused by this process?

Options:

The result was that APs were above and below each other on the same channel, resulting in excessive CCI The APs should have been deployed so that they were not directly above and below each other and so that they used varying channels between floors

The result was that clients could only connect to APs on their floor and, in a multi-floor deployment, you want clients to connect to APs on other floors in case they roam between floors.

The result was that AC) was increased because the APs were deployed above and below each other on the same channels.

The result was that the frequency utilization was too low for the clients to capture RF waves on which to transmit their signals.

Page: 2 / 20