CCNP Enterprise 300-410 Exam Dumps

Set a tag in the route map when redistributing EIGRP into OSPF on R1. and match the same tag on R2 to allow when redistributing OSPF into EIGRP.

Apply a prefix list of EIGRP network routes in OSPF domain on R1 to propagate back into the EIGRP routing domain.

Set a tag in the route map when redistributing EIGRP into OSPF on R1, and match the same tag on R2 to deny when redistributing OSPF into EIGRP.

Advertise summary routes of EIGRP to OSPF and deny specific EIGRP routes when redistributing into OSPF.

Interface Tunnel1

no ip split-horizon eigrp 111

Interface Tunnel1

Ip next-hop-self elgrp 111

Interface Tunnel1

tunnel mode Ipsec Ipv4

Interface Tunnel1

tunnel protection ipsec profile IPSec-PROFILE

The label edge router swaps labels on the received packets.

Labels are imposed in packets after the Layer 3 header.

LDP uses TCP for reliable delivery of information.

An MPLS label is a short identifier that identifies a forwarding equivalence class.

A maximum of two labels can be imposed on an MPLS packet.

Enable the IPv4 address family under the E 0/0 interface by using the address-family Ipv4 unicast command

Disable IPv6 on the E 0/0 interface using the no ipv6 enable command

Enable the IPv4 address family under the router ospfv3 4 process by using the address-family ipv4 unicast command

Disable OSPF for IPv4 using the no ospfv3 4 area 0 ipv4 command under the E 0/0 interface.