Weekend Special 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: Board70

AP0-001 Exam Dumps - Acme Packet Certifications Questions and Answers

Question # 4

In a high availability (HA) cluster, a network administrator could trigger a system switchover manually from the __________ Net-Net 4000 by issuing the notify berpd force command.

Options:

A.

Standby or Active

B.

Active only

C.

Standby only

D.

Active node that no longer has a heartbeat

Buy Now
Question # 5

High availability (HA) nodes identify one another by their __________ names.

Options:

A.

Identifier

B.

Host

C.

mib-system-name

D.

target

Buy Now
Question # 6

In a Net-Net 4000 high availability (HA) architecture, the standby Net-Net 4000 sends ARP requests using which one of the following?

Options:

A.

The utility IP address and its hard coded MAC address.

B.

The IP address and its hard coded MAC address.

C.

The virtual IP address and its virtual MAC address.

D.

The utility IP address and the configured virtual MAC address.

Buy Now
Question # 7

You have copied a new Net-Net OS to the Net-Net 4000 and changed the boot parameters according to the display below. On reboot, the Net-Net 4000 is in a boot loop.

training1# check-space-remaining boot boot:

0/29702144 bytes (0%) remaining

training1# configure terminal

training1(configure)# bootparam

'.' = clear field; '-' = go to previous field; q = quit

boot device : wancom0

processor number : 0

host name :

file name : /tffs0/sd200p23.gz /tffs0/sd400q10.gz

inet on ethernet (e) : 10.0.3.11:ffff0000

inet on backplane (b) :

host inet (h) : 10.0.3.1

gateway inet (g) : 10.0.0.1

user (u) : anonymous

ftp password (pw) (blank = use rsh) : anonymous

flags (f) : 0x80008

target name (tn) : training1

startup script (s) :

other (o) :

NOTE: These changed parameters will not go into effect until reboot. Also, be aware that some boot parameters may also be changed through PHY and Network Interface Configurations.

training1(configure)# exit

training1# reboot force

Based on the information above, which three of the following scenarios could be the cause of the boot loop?

Options:

A.

You did not copy the Net-Net OS file into the /boot directory.

B.

The Net-Net OS file was truncated while being copied to the /boot directory due to lack of file space.

C.

You mistyped the name of the Net-Net OS file in the file name property of the boot parameters.

D.

The Net-Net 4000 was reset using the reboot force command without saving and activating the configuration changes first.

Buy Now
Question # 8

Examine the output below from the network interface configuration.

When the Net-Net 4000 does not get an ARP response from the device configured as its gateway in the configured retry time period, it will____________.

Options:

A.

send traffic to the device configured in the sec-gateway field

B.

decrement its health score to 50 which may result in a failover to the standby

C.

use the Virtual Router Redundancy Protocol (VRRP) to determine a new default gateway

D.

use the Virtual Router Redundancy Protocol (VRRP) to the host(s) instead of the primary gateway

Buy Now
Question # 9

When configuring the Net-Net 4000 to proxy registrations in the H323 stack element, the ___________.

Options:

A.

process-registration parameter must be disabled in the H323 stack for the access network.

B.

proxy-mode parameter in the H323 stack must be set to enabled.

C.

tcp-keepalive parameter must always be disabled.

D.

Q.931 and dynamic port range must not overlap.

Buy Now
Question # 10

Which one of the following statements is TRUE when H245 tunneling is enabled on the Net-Net 4000. The Net-Net 4000 will________________.

Options:

A.

tunnel signaling messages over the H.245 connection

B.

establish a separate TCP connection to tunnel messages

C.

tunnel H.245 messages over H.225.0 FACILITY messages

D.

support the Generic Tunneling Protocol (GTP) for sending SIP messages over the H.245 connection

Buy Now
Question # 11

To enable the Net-Net 4000 to provide next hop signaling load balancing, which two of the following licenses must be installed?

Options:

A.

session agent group

B.

load balancing

C.

routing

D.

local policy

Buy Now
Question # 12

How many simultaneous Telnet sessions does the Net-Net 4000 support in configuration mode in standard Net-Net OS version 2.x and above?

Options:

A.

5

B.

2

C.

1

D.

10

Buy Now
Question # 13

When SIP sessions are terminated and re-originated as they flow through the Net-Net 4000, the ____________ is rewritten to force all session related media to be routed through Net-Net 4000.

Options:

A.

Via

B.

From

C.

SDP

D.

Contact

Buy Now
Exam Code: AP0-001
Exam Name: Acme Packet Certification Certification Exams Boot camp & Braindump
Last Update: Feb 22, 2025
Questions: 140
AP0-001 pdf

AP0-001 PDF

$25.5  $84.99
AP0-001 Engine

AP0-001 Testing Engine

$28.5  $94.99
AP0-001 PDF + Engine

AP0-001 PDF + Testing Engine

$40.5  $134.99