Authentic EMC Certification Exam D-PST-MN-A-24 Questions Answers

The reason for the best practice of leaving 2 Us of space at the bottom of the rack when racking Dell EMC PowerStore systems is toleave room for serviceability.

When installing a Dell EMC PowerStore system, it is recommended to leave 2 Us of space at the bottom of the rack.

This space is not for cooling, wheel clearance, or stability, but rather to ensure that there is enough room for service activities1.

Serviceability involves the ability to access and maintain hardware components easily. The additional space allows for better maneuverability and access to the system for maintenance and repairs.

Following this best practice helps in preventing potential issues that might arise from cramped spaces, which can make it difficult to perform necessary service tasks1.

For more detailed information on installation best practices, refer to the Dell EMC PowerStore Quick Start Guide or the Best Practices Guide21.

The type of device supported in expansion enclosures for Dell PowerStore systems isNVMe SSD.

Starting with PowerStoreOS 3.0, the PowerStore models 500, 1200, 3200, 5200, and 9200 support 24-drive 2U NVMe expansion enclosures using 2.5-inch NVMe SSD drives for additional capacity1.

The NVMe expansion enclosures do not support NVMe SCM drives1.

The base enclosure can support all NVMe SSDs or a mix of NVMe SSDs and NVMe SCM drives (for the metadata tier) with an NVMe expansion enclosure attached1.

Before attaching an NVMe expansion enclosure, all drive slots 0 to 21 in the base enclosure must be populated1.

Each appliance in a PowerStore cluster supports up to three NVMe expansion enclosures1.

For more detailed information on the supported devices in expansion enclosures for Dell PowerStore systems, you can refer to the Dell PowerStore: Technical Primer1.

For a Dell EMC PowerStore X implementation, a minimum of six IP addresses are required for the storage network. This is to accommodate the various components that need network connectivity within the PowerStore infrastructure1.

The allocation of these IP addresses typically includes:

•Two IP addresses for the storage processors or nodes within the PowerStore appliance.

•Two IP addresses for the management interfaces.

•Two additional IP addresses for redundancy or other network services.

It’s important to plan the network configuration carefully to ensure that there are enough IP addresses available for all required services and for future expansion. For optimization and best practices in IP address allocation, administrators should refer to the Dell EMC PowerStore Networking Guide for Storage Services2. This guide provides detailed information on network requirements, including IP address allocation and network design considerations for PowerStore systems.