4A0-C04 Exam Dumps - Nokia Network Routing Specialist II (NRS II) Questions and Answers

RIPv1 and RIPv2

OSPF

IS-IS

BGP

The Standby with the highest next-hop IP.

The first Standby in the list.

The Standby with the longest uptime.

The Standby with the lowest next-hop IP.

Option A

Option B

Option C

Option D

Policy changes are delayed until the peer router with the affected routes reboots.

Policy changes are delayed until route updates for affected BGP routes are received from peers.

Policy changes are delayed until BGP sessions are cleared or BGP is reset.

Policy changes are delayed until the router reboots.

The router does not have a route to reach to the peer 10.10.10.2/32.

The router does not have a route to reach to the prefix 192.10.1.2/32.

The router does not have an export policy defined to export the prefix 192.10.1.2/32 into LDP.

The router receives an invalid label for the prefix 192.10.1.2/32 from its peer.

1

3

6

12

Hello, Link State Update, Link State Packet, Link State Acknowledgement, Database Descriptor

Link State Update, Link State Refresh, Link State Acknowledgement, Database Descriptor, Notification

Hello, Link State Refresh, Link State Update, Link State Acknowledgement, Link State Authentication

Hello, Link State Update, Link State Request, Link State Acknowledgement, Database Descriptor

An LSR answers requests for label mappings immediately, without waiting for a label mapping from the next-hop.

An LSR advertises label mappings to all peers for which it might be a next-hop for a given FEC.

An LSR distributes a label mapping for a FEC when it has been requested to do so.

An LSR propagates a label mapping downstream for a FEC. only if it has a label mapping for the FEC's next-hop.

The router R6 interface is in a multi-access segment. It is neither the DR nor the BDR for the segment. The DR for this segment would be the router with router ID 10.10.10.5.

The router R6 interface is in a multi-access segment. It is neither the DR nor the BDR for the segment; however, this command does not indicate whether 10.10.10.3 or 10.10.10.5 is the DR or BDR.

The router R6 interface is in a multi-access segment. It is the BDR, which is why it is not adjacent to the other routers.

The router R6 interface is in a multi-access segment. It is neither the DR nor the BDR for the segment. The DR for this segment would be the router with router ID 10.10.10.3.

An echo request is sent based on the LSP's label stack.

Echo reply packets may not take the same path as the LSP.

The IP destination address is used to initiate echo requests,

The test fails if the LSP is not operationally up.