300-620 Exam Dumps - Cisco CCNP Data Center Questions and Answers

Upgrade the APIC controllers by selecting the desired firmware and choosing Upgrade Now.

Divide the switches into two upgrade groups: spines and leaves.

Start the firmware upgrade on the spine upgrade group and then proceed with the leaf upgrade group.

Upgrade the APIC controllers by initiating the upgrade process that uses the most recent uploaded firmware.

Divide the switches into three upgrade groups: spines, 1-Gb switches, and 10-Gb switches.

Start the firmware upgrade on the spine upgrade group and then proceed with the other two groups.

Upgrade the APIC controllers by selecting the desired firmware and choosing Upgrade Now.

Divide the switches into two upgrade groups with one spine, one 1-Gb switch, and one 10-Gb switch per group.

Start the firmware upgrade on the first upgrade group and when it finishes, start the second upgrade group.

Upgrade the APIC controllers as a single group by selecting the firmware and choosing Upgrade Now.

Divide the switches into four upgrade groups with one switch per group.

Start the firmware upgrade on each upgrade group in succession until all four are complete.

spine switch port

APIC console port

leaf access port

management port

The leaf switch does not learn the source endpoint through data plane learning.

The leaf switch drops the traffic that is destined to the endpoint.

The leaf switch floods the traffic to the endpoint throughout the fabric.

The leaf switch sends the traffic to the wrong destination leaf.

The APIC uses an internal IP address from a pool to communicate with the nodes.

Every switch is assigned a unique AV by the APIC.

The APIC discovers the IP address of the other APIC controllers by using Cisco Discovery Protocol.

The ACI fabric is discovered starting with the spine switches.