Which controller is used for provisioning and configuration in a Cisco SD-WAN solution?
What is the threshold to generate a warning alert about CPU or memory usage on a WAN Edge router?
An enterprise deployed a Cisco SD-WAN solution with hub-and-spoke topology using MPLS as the preferred network over the Internet. A network engineer must implement an application-aware routing policy to allow ICMP traffic to be load-balanced over both the available links. Which configuration meets the requirement?
A)
B)
C)
D)
Which two prerequisites must be met before the Cloud onRamp for laaS is initiated on vManage to expand to the AWS cloud? (Choose two)
Which protocol is used to measure loss latency, Jitter, and liveliness of the tunnel between WAN Edge router peers?
Which device in the SD- WAN solution receives and categorizes event reports, and generates alarms?
Refer to the exhibit, Which configuration routes Site 2 through the firewall in Site 1?
Which protocol runs between the vSmart controllers and WAN Edge routers when the vSmart controller acts like a route reflector?
Refer to the exhibit.
A customer wants to implement primary and secondary Cisco SD-WAN overlay routing for prefixes that are advertised for both data centers. The east data center (TLOC 101.101.101.101) is primary for east sites, and the west data center (TLOC 100.100.100.100) is primary for west sites. Which configuration change achieves this objective?
An engineer is configuring a shaping rate of 1 Mbps on the WAN link of a WAN Edge router Which configuration accomplishes this task’?
TESTED 23 Feb 2025
