Special Summer Sale 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: Board70

300-410 Exam Dumps - Cisco CCNP Enterprise Questions and Answers

Question # 34

Options:

Buy Now
Question # 35

Refer to the exhibit.

An administrator is attempting to disable the automatic logout after a period of inactivity. After logging out the console stopped responding to all keyword inputs. Remote access through SSH still work resolves the issue?

Options:

A.

Configure the exec command on line con 0.

B.

Configure the absolute-timeout command on line con 0.

C.

Configure the default exec-timeout command on line con 0.

D.

Configure the no exec-timeout command on line con 0.

Buy Now
Question # 36

What is a characteristic of IPv6 RA Guard?

Options:

A.

RA messages are allowed from the host port to the switch

B.

It is unable to protect tunneled traffic

C.

It filters rogue RA broadcasts from connected hosts

D.

It is supported on the egress direction of the switch

Buy Now
Question # 37

Refer to the exhibit.

An engineer configures the router 10.1.100.10 for EIGRP autosummarization so that R1 should receive the summary route of 10.0.0.0/8. However, R1 receives more specific /24 routes.

Which action resolves this issue?

Options:

A.

Router R1 should configure ip summary address eigrp (AS number) 10.0.0.0 255.0.0.0 for the R1 Fast Ethernet 0/0 connected interface.

B.

Router R1 should configure ip route 10.0.0.0 255.0.0.0 null 0 for the routes that are received on R1.

C.

Router 10.1.100.10 should configure ip route 10.0.0.0 255.0.0.0 null 0 for the routes that are summarized toward R1.

D.

Router 10.1.100.10 should configure ip summary address eigrp (AS number) 10.0.0.0 255.0.0.0 for the R1 Fast Ethernet 0/0 connected interface.

Buy Now
Question # 38

Which table is used to map the packets in an MPLS LSP that exit from the same interface, via the same next hop, and have the same queuing policies?

Options:

A.

RIB

B.

FEC

C.

LDP

D.

CEF

Buy Now
Question # 39

What are the two prerequisites to enable BFD on Cisco routers? (Choose two)

Options:

A.

A supported IP routing protocol must be configured on the participating routers.

B.

OSPF Demand Circuit must run BFD on all participating routers.

C.

ICMP must be allowed on all participating routers.

D.

UDP port 1985 must be allowed on all participating routers.

E.

Cisco Express Forwarding and IP Routing must be enabled on all participating routers.

Buy Now
Question # 40

Which router attaches the VPN label to incoming packets from CE routing?

Options:

A.

CE router

B.

core router

C.

P router

D.

PE router

Buy Now
Question # 41

Refer to the exhibit.

Which two commands provide the administrator with the information needed to resolve the issue? (Choose two.)

Options:

A.

snmp user

B.

debug snmp engine-id

C.

debug snmpv3 engine-id

D.

debug snmp packet

E.

showsnmpv3 user

Buy Now
Question # 42

Refer to the exhibit.

R1 is configured with IP SLA to check the availability of the server behind R6 but it kept failing. Which configuration resolves the issue?

Options:

A.

R1(config)# ip sla 700R1(config-track)# delay down 30 up 20

B.

R1(config)# ip sla 700R1(config-track)# delay down 20 up 30

C.

R1(config)# track 700 ip sla 700R1(config-track)# delay down 30 up 20

D.

R1(config)# track 700 ip sla 700R1(config-track)# delay down 20 up 30

Buy Now
Question # 43

The network administrator configured CoPP so that all HTTP and HTTPS traffic from the administrator device located at 172.16 1.99 toward the router CPU is limited to 500 kbps. Any traffic that exceeds this limit must be dropped.

access-list 100 permit ip host 172.16.1.99 any

!

class-map CM-ADMIN

match access-group 100

!

policy-map PM-COPP

class CM-ADMIN

police 500000 conform-action transmit

!

interface E0/0

service-policy input PM-COPP

CoPP failed to capture the desired traffic and the CPU load is getting higher.

Which two configurations resolve the issue? (Choose two.)

Options:

A.

interface E0/0no service-policy input PM-COPP!control-planeservice-policy input PM-COPP

B.

policy-map PM-COPPclass CM-ADMINno police 500000 conform-action transmitpolice 500 conform-action transmit!control-planeservice-policy input PM-COPP

C.

no access-list 100access-list 100 permit tcp host 172.16.1.99 any eq 80

D.

no access-list 100access-list 100 permit tcp host 172.16.1.99 any eq 80access-list 100 permit tcp host 172.16.1.99 any eq 443

E.

policy-map PM-COPPclass CM-ADMINno police 500000 conform-action transmitpolice 500 conform-action transmit

Buy Now
Question # 44

A network administrator is troubleshooting a high utilization issue on the route processor of a router that was reported by NMS The administrator logged into the router to check the control plane policing and observed that the BGP process is dropping a high number of routing packets and causing thousands of routes to recalculate frequently. Which solution resolves this issue?

Options:

A.

Police the cir for BGP, conform-action transmit, and exceed action transmit.

B.

Shape the pir for BGP, conform-action set-prec-transmit, and exceed action set-frde-transmit.

C.

Shape the cir for BGP. conform-action transmit, and exceed action transmit.

D.

Police the pir for BGP, conform-action set-prec-transmit, and exceed action set-clp-transmit.

Buy Now
Question # 45

Refer to the exhibit.

An engineer configured IP SLA on R1 to avoid the ISP link flapping problem. but it is not working as designed IP SLA should wait 30 seconds before switching traffic to a secondary connection and then revert to the primary link after waning 20 seconds, when the primary link is available and stabilized. Which configuration resolves the issue?

Options:

A.

R1(config)#ip sla 700R1(config-ip-sla)#delay down 30 up 20

B.

R1(config)#ip sla 700R1(config-ip-sla)#delay down 20 up 30

C.

R1(config)#track 700 ip sla 700R1(config-track)#delay down 30 up 20

D.

R1(config)#track 700 ip sla 700R1(config-track)#delay down 20 up 30

Buy Now
Question # 46

Refer to the exhibit.

An engineer configured NetFlow on R1, but the NMS server cannot see the flow from R1. Which configuration resolves the issue?

Options:

A.

flow monitor Flowmonitor1destination 10.221.10.11

B.

flow exporter FlowAnalyzer1destination 10.221.10.11

C.

interface Ethernet0/1flow-destination 10.221.10.11

D.

interface Ethernet0/0flow-destination 10.221.10.11

Buy Now
Question # 47

Which two solutions are used to overcome a flapping link that causes a frequent label binding

exchange between MPLS routers? (Choose two)

Options:

A.

Create link dampening on links to protect the session.

B.

Increase input queue on links to protect the session.

C.

Create targeted hellos to protect the session.

D.

Increase a hold-timer to protect the session.

E.

Increase a session delay to protect the session.

Buy Now
Question # 48

Refer to the exhibit.

An administrator is configuring a GRE tunnel to establish an EIGRP neighbor to a remote router. The

other tunnel endpoint is already configured. After applying the configuration as shown, the tunnel

started flapping. Which action resolves the issue?

Options:

A.

Modify the network command to use the Tunnel0 interface netmask

B.

Advertise the Loopback0 interface from R2 across the tunnel

C.

Stop sending a route matching the tunnel destination across the tunnel

D.

Readdress the IP network on the Tunnel0 on both routers using the /31 netmask

Buy Now
Exam Code: 300-410
Exam Name: Implementing Cisco Enterprise Advanced Routing and Services (300-410 ENARSI)
Last Update: Mar 31, 2025
Questions: 594
300-410 pdf

300-410 PDF

$28.5  $94.99
300-410 Engine

300-410 Testing Engine

$33  $109.99
300-410 PDF + Engine

300-410 PDF + Testing Engine

$43.5  $144.99