NSE6_FWF-6.4 Exam Dumps - Fortinet NSE 6 Network Security Specialist Questions and Answers

Using the current number of wireless clients connected to the SSID and the number of IPs available in the least busy VLAN

Using the current number of wireless clients connected to the SSID and the number of clients allocated to each of the VLANs

Using the current number of wireless clients connected to the SSID and the number of VLANs available in the pool

Using the current number of wireless clients connected to the SSID and the group the FortiAP is a member of

Gathering details about on site visitors

Predicting the number of guest users visiting on-site

Comparing current data with historical records

Reporting potential threats by guests on site

When the AP detects any other wireless signal stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.

When the AP detects PF Interference from an unknown source such as a cordless phone with a signal stronger that -70 dBm, it will increase its transmission power until it reaches the maximum configured TX power limit.

When the AP detects any wireless client signal weaker than -70 dBm, it will reduce its transmission power until it reaches the maximum configured TX power limit.

When the AP detects any interference from a trusted neighboring AP stronger that -70 dBm, it will reduce its transmission power until it reaches the minimum configured TX power limit.

DARRP performs continuous spectrum analysis to detect sources of interference. It uses this information to allow the AP to select the optimum channel.

DARRP performs measurements of the number of BSSIDs and their signal strength (RSSI). The controller then uses this information to select the optimum channel for the AP.

DARRP measurements can be scheduled to occur at specific times.

DARRP requires that wireless intrusion detection (WIDS) be enabled to detect neighboring devices.