Review the exhibit.
Cell A has neighbor relations with cells B and C which share the same frequency and PCI. Cells B and C do not share any overlapping area.
Referring to the exhibit which statement is correct?
Review the exhibit.
A new residential area has recently been built showing a lack of 3G uplink coverage as shown in the exhibit. The terrain is flat and all the buildings in the area are 20 meters in height with no other relevant direct obstacles.
What should be applied to cells A_l and 8_1 to provide 3G service to the new area knowing that both cells have a soft handover (SHO) factor of 1.9?
An operator receives customer complaints from an indoor location. The Issues result from a bad neighbor plan in a single RAT and frequency network.
Which two optimization processes would you use to resolve the problem? (Choose two.)
Which KPI must be captured in a drive test with TEMS to review VoLTE accessibility?
After the installation of a new LTE antenna on a roof top, UL interference power for that sector is observed.
In this scenario, which two situations would cause the interference? (Choose two.)
You have collocated sectors In your 2G network on the GSM 900 and the DCS 1800 bands. Reviewing the network level traffic distribution, you noticed that the GSM 900 sectors have five times more traffic than the DCS 1800 sectors.
Which two actions would improve load balancing between these bands? (Choose two.)
Review the exhibit.
An operator's LTE single layer network has a cell not carrying enough traffic. To increase the traffic carried by the cell, the operator decides to modify the Idle mode behavior of the cell. Values for the qRxLevMin and qQuaimin parameters are currently set to -120 dBm and -12 dB.
Referring to the exhibit, which two configurations would be used to potentially increase the traffic carried by this cell? (Choose two.)
A customer is deploying VoLTE and complains about high voice drop rates and voice quality degradation at the cell edge in most LTE cells in the area. The network has a dense WCDMA coverage on the 700 MHz band and patchy LTE coverage on the 2100 MHz band.
Which two features would you activate to solve this problem? (Choose two.)
TESTED 22 Feb 2025
