XK0-005 Exam Results

 The command that should be run on the DNS forwarder server to accomplish the task is firewall-cmd --zone=public --add-port=53/udp --permanent. The firewall-cmd command is a tool for managing firewalld, which is a firewall service that provides dynamic and persistent network security on Linux systems. The firewalld uses zones and services to define the rules and policies for the network traffic. The zones are logical groups of network interfaces and sources that have the same level of trust and security. The services are predefined sets of ports and protocols that are associated with certain applications or functions. The --zone=public option specifies the zone name that the rule applies to. The public zone is the default zone that represents the untrusted network, such as the internet. The --add-port=53/udp option adds a port and protocol to the zone. The 53 is the port number that is used by the DNS service. The udp is the protocol that is used by the DNS service. The --permanent option makes the change persistent across reboots. The command firewall-cmd --zone=public --add-port=53/udp --permanent will modify the firewall on the server for the DNS forwarder to allow the internal servers to communicate to it and make the changes persistent between server reboots. This is the correct command to use to accomplish the task. The other options are incorrect because they either do not modify the firewall on the server for the DNS forwarder (ufw allow out dns or systemct1 reload firewalld) or do not use the correct syntax for the command (iptables -A OUTPUT -p udp -ra udp -dport 53 -j ACCEPT instead of iptables -A OUTPUT -p udp -ra udp --dport 53 -j ACCEPT). References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 12: Managing Network Connections, page 392.

The chage command can be used to change the user password expiry information. The -d or --lastday option sets the last password change date. If the value is 0, the user will be forced to change the password at the next login. See chage command in Linux with examples and 10 chage command examples in Linux.

The git pull command fetches changes from the remote repository and merges them into the current branch. This is the correct command for obtaining the updated configuration that was pushed to the remote repository.

The correct sequence of commands to expand a volume group using a new disk is fdisk, pvcreate, vgextend. The fdisk command can be used to create a partition on the new disk with the type 8e (Linux LVM). The pvcreate command can be used to initialize the partition as a physical volume for LVM. The vgextend command can be used to add the physical volume to an existing volume group. The partprobe command can be used to inform the kernel about partition table changes, but it is not necessary in this case. The vgcreate command can be used to create a new volume group, not expand an existing one. The lvextend command can be used to extend a logical volume, not a volume group. The lvcreate command can be used to create a new logical volume, not expand a volume group. The mkfs command can be used to create a filesystem on a partition or a logical volume, not expand a volume group. References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 14: Managing Disk Storage, pages 462-463.