SK0-005 Leak Questions

Scenario: Installing Windows on an 8TB drive, aiming for a single 8TB partition.

Solution: Use the GPT (GUID Partition Table) option (Option C):

GPT supports larger partitions (up to 18.4 million TB) compared to MBR (limited to 2TB).

VMFS, ZFS, and LVM are unrelated to the partitioning scheme in Windows.

The most likely issue that prevents the newly added server from seeing any of the LUNs on the SAN is that a single-mode fiber cable is used in place of multimode. A single-mode fiber cable is a type of optical fiber cable that has a small core diameter and allows only one mode of light to propagate through it. A single-mode fiber cable can transmit data over long distances at high speeds, but it requires more expensive transceivers and connectors than multimode fiber cables. A multimode fiber cable is a type of optical fiber cable that has a larger core diameter and allows multiple modes of light to propagate through it. A multimode fiber cable can transmit data over short distances at lower speeds than single-mode fiber cables, but it is more compatible and cost-effective than single-mode fiber cables. If a single-mode fiber cable is used in place of multimode, it can cause signal loss, attenuation, or mismatch between the devices. References: [CompTIA Server+ Certification Exam Objectives], Domain 3.0: Storage, Objective 3.2: Given a scenario, compare and contrast various storage technologies.

 Application consistent backup is a method of backing up data that ensures the integrity and consistency of the application state. It involves notifying the application to flush its data from memory to disk and quiescing any write operations before taking a snapshot of the data. If the databases were not backed up to be application consistent, they might contain incomplete or corrupted data that cannot be restored properly.

References:

CompTIA Server+ Certification Exam Objectives1, page 12

What is Application Consistent Backup and How to Achieve It2

Application-Consistent Backups3

The IP address configuration that the technician should assign to the new server so the members of the accounting group can access the server is 172.16.25.90/24 for the IP address and 172.16.25.254 for the default gateway. This configuration matches the VLAN identified in the image, which has a network address of 172.16.25.0/24 and a subnet mask of 255.255.255.0. The IP address of the server must be within the same network range as the VLAN, which is from 172.16.25.1 to 172.16.25.254, excluding the network and broadcast addresses (172.16.25.0 and 172.16.25.255). The default gateway of the server must be the same as the VLAN, which is 172.16.25.254, to allow communication with other networks or devices outside the VLAN. References: [CompTIA Server+ Certification Exam Objectives], Domain 4.0: Networking, Objective 4.1: Given a scenario, configure network settings for servers.