PDF 1z0-076 Study Guide

To set up Transparent Application Failover (TAF) in a Data Guard environment with RAC, you would need to:

• On a node of the standby database cluster, execute the srvctl command to add the oltpworkload service for the PRIMARY role (1): This prepares the standby cluster to provide the oltpworkload service in case a failover occurs, and the standby becomes the primary database.
• Make sure clients use the OLTPWORKLOAD service to connect to the database instances (4): This ensures that client connections are directed to the correct service, which is managed by TAF and can fail over in case of a primary database outage.References:
• Oracle Real Application Clusters Administration and Deployment Guide
• Oracle Data Guard Concepts and Administration Guide

• Synchronous redo transport for zero data loss (B): To guarantee zero data loss in the case of a disaster, synchronous redo transport must be configured between the primary and standby databases.
• Conversion to snapshot standby for testing (B): A physical standby database can be temporarily converted into a snapshot standby database to perform real application testing. After testing is completed, the snapshot standby can be converted back to a physical standby to resume its disaster recovery role.

References:

• Oracle Data Guard Concepts and Administration Guide
• Oracle Database Testing Guide

To automate the instantiation of a PDB in the standby database after creating a remote clone in the primary database, certain conditions must be met:

• Open PDBI (remote clone source) in Read Only (A): The source PDB from which the clone is created must be open in read-only mode to ensure a consistent state during cloning.
• Set STANDBY_PDB_SOURCE_FILE_DIRECTORY to in the london database (C): This parameter specifies the location on the standby database where the files from the source PDB should be placed.
• Set STANDBY_FILE_MANAGEMENT to auto in the london database (F): This parameter automates the management of file changes on the standby database when structural changes occur on the primary database, ensuring that the clone operation is reflected automatically on the standby.References:
• Oracle Multitenant Administrator's Guide
• Oracle Data Guard Broker documentation

The error indicates that switching the protection mode to Maximum Protection is not possible due to the presence of a snapshot standby database in the Data Guard configuration, which cannot participate in synchronous redo transport required by the Maximum Protection mode. Therefore, the correct answer is:

• D. Cats is a snapshot standby database.

Comprehensive Detailed Explanation:In an Oracle Data Guard environment, the Maximum Protection mode requires that all redo data be transmitted synchronously to at least one standby database, ensuring no data loss even in the event of a primary database failure. However, a snapshot standby database, by its nature, allows read-write access and is temporarily disconnected from the redo stream, which makes it unable to participate in the synchronous redo transport required by Maximum Protection mode. The presence of a snapshot standby database in the Data Guard configuration thus prevents the activation of Maximum Protection mode, as it cannot guarantee zero data loss without a standby database capable of receiving redo data synchronously.

References:Oracle Data Guard documentation clearly outlines the requirements and restrictions of different protection modes, including the necessity for standby databases to participate in synchronous redo transport to enable Maximum Protection mode. The inability of snapshot standby databases to fulfill this requirement is a key consideration when planning Data Guard configurations and protection levels.