Linux+ XK0-005 Syllabus Exam Questions Answers

mtr (My Traceroute) is a network diagnostic tool that combines the functionality of traceroute and ping. It shows real-time packet loss and latency on a hop-by-hop basis. The -T option uses TCP instead of ICMP, and the -P 443 option specifies the remote port. This provides the best method for checking packet loss on port 443.

"modify the /etc/fstab text file to automatically mount the new partition by opening it in an editor and adding the following line:

/dev/ xxx 1 /data ext4 defaults 1 2

where xxx is the device name of the storage device"

https://learning.oreilly.com/library/view/mastering-linux-system/9781119794455/b01.xhtml

To configure a new filesystem that needs the capability to be mounted persistently across reboots, two commands are needed: mkfs.ext4 /dev/sdc1 and echo “/dev/sdc1 /data ext4 defaults 0 0” >> /etc/fstab. The first command creates an ext4 filesystem on the device /dev/sdc1, which is the partition that will be used for the new filesystem. The second command appends a line to the /etc/fstab file, which is the configuration file that controls persistent mount points of filesystems. The line specifies the device name, the mount point (/data), the filesystem type (ext4), the mount options (defaults), and the dump and pass values (0 0). The other commands are incorrect because they either do not create or configure a filesystem, or they have wrong syntax or arguments. References: CompTIA Linux+ Study Guide, Fourth Edition, page 409-410, 414-415.

Again, the correct command to list all installed snap packages is snap list. This command provides information about installed snap applications and their versions, helping the administrator verify the package installation.

The command that is used to configure the default permissions for new files is umask. The umask command is a tool for setting the default permissions for new files and directories on Linux systems. The umask value is a four-digit octal number that represents the permissions that are subtracted from the default permissions. The default permissions for files are 666, which means read and write for owner, group, and others. The default permissions for directories are 777, which means read, write, and execute for owner, group, and others. The umask value consists of four digits: the first digit is for special permissions, such as setuid, setgid, and sticky bit; the second digit is for the owner permissions; the third digit is for the group permissions; and the fourth digit is for the others permissions. The umask value can be calculated by subtracting the desired permissions from the default permissions. For example, if the desired permissions for files are 664, which means read and write for owner and group, and read for others, then the umask value is 002, which is 666 - 664. The command umask 002 will set the umask value to 002, which will ensure that only file owners and group members can modify new files by default. The command that is used to configure the default permissions for new files is umask. This is the correct answer to the question. The other options are incorrect because they either do not set the default permissions for new files (setenforce, sudo, or chmod) or do not exist (kill -HUP or kill -TERM). References: CompTIA Linux+ (XK0-005) Certification Study Guide, Chapter 11: Managing File Permissions and Ownership, page 349.