HCSA-Field-Transmission H35-260 Updated Exam

The default route is configured on the L2/3 master node, and the next-hop points to the L3 master node

A default route is configured on the L2/L3 standby node, and the next hop points to the L3 master node

On the L3 raw node, configure a default route with the next hop pointing to the main L2/L3 node

Configure the default route on the standby point, and the next hop points to the standby L2/L3 node

It is composed of all L2 routers (including L1/L2)

can be discontinuous

For inter-area routing

Identify with area 0

After the hardware inspection of the single station is completed, make sure that all power switches are in the off position

It is strictly forbidden to plug and unplug the power plug and PIU single board while electrified

In the case of power failure, you can contact the board without wearing an anti-static wrist or anti-static gloves

If the input voltage of the equipment is not within the required range, a rectification suggestion should be put forward, and power-on is strictly

prohibited

4,4

4,2

2,2

2,4