Winter Special Limited Time 65% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: bigdisc65

HCIE-Datacom H12-891_V1.0 Passing Score

Page: 5 / 22
Question 20

HW users are transferring a very large number of files via TFTP. What protocol does TFTP rely on for transmission?

Options:

A.

ICMP and UDP

B.

IP ?TCP

C.

UDP

D.

NFS E. FTP

Question 21

The RSTP protocol provides a variety of protection functions, such as when the edge port is configured as a protection state, the edge port receives the BPDU packet processing method;

Options:

A.

Directly discard the BPDU packet

B.

Close the port

C.

After parsing the BPDU message, the relevant information is obtained

D.

Forward BPDU packets as required

Question 22

Auto-negotiate mode is to obtain the maximum interface rate and operating mode, the network administrator configures all Ethernet interface rates of a working switch to 10OMbps, and the operating mode is configured as Full-duplex, when a network card is configured After the auto-negotiate workstation is connected to the switch, the negotiation result is that the interface rate is 10OMbps and the working mode is half-duplex, which of the following explanations is the most reasonable for this phenomenon?

Options:

A.

The problem is on the workstation's NIC, mostly due to the aging of the NIC driver on the workstation , which causes the workstation NIC to learn the interface rate and operating mode configured on the switch

B.

Port rate negotiation is negotiated through the initial port sending FLP , and the operating mode is not negotiated through FLP

C.

STP initializes the port into the blocking state, causing auto-negotiation to fail, so the port should be configured as an edge port

D.

At higher port rates and operating modes, the workstation's network interface card cannot be configured as auto-negotiate

E.

Auto-negotiation is not configured on the switch, resulting in the switch not being able to send FLP messages to the workstation, causing the workstation to set its own operating mode to Half-duple

Question 23

Regarding the sliding window of TCP, what are the following descriptions that are enough to be wrong? ( Multiple choice question)

Options:

A.

The sender declares the initial window size

B.

The sender does not need to transmit messages of full window size

C.

The TCP sliding window allows multiple packets to be sent before an acknowledgment is received

D.

After the retransmission timer times out, the sender has not received an acknowledgment and will retransmit unacknowledged data

E.

The receiver needs to acknowledge the sender's packet

F.

Sliding window size can only be increased or remain unchanged

Page: 5 / 22
Exam Code: H12-891_V1.0
Exam Name: HCIE-Datacom V1.0
Last Update: Nov 21, 2024
Questions: 610
H12-891_V1.0 pdf

H12-891_V1.0 PDF

$28  $80
H12-891_V1.0 Engine

H12-891_V1.0 Testing Engine

$33.25  $95
H12-891_V1.0 PDF + Engine

H12-891_V1.0 PDF + Testing Engine

$45.5  $130