Full Access Fortinet NSE7_EFW-7.0 Tutorials

Page: 5 / 5

Question 20

An administrator has configured a FortiGate device with two VDOMs: root and internal. The administrator has also created and inter-VDOM link that connects both VDOMs. The objective is to have each VDOM advertise some routes to the other VDOM via OSPF through the inter-VDOM link. What OSPF configuration settings must match in both VDOMs to have the OSPF adjacency successfully forming? (Choose three.)

Options:

Router ID.

OSPF interface area.

OSPF interface cost.

OSPF interface MTU.

Interface subnet mask.

Question 21

Examine the output of the ‘get router info ospf interface’ command shown in the exhibit; then answer the question below.

Which statements are true regarding the above output? (Choose two.)

Options:

The port4 interface is connected to the OSPF backbone area.

The local FortiGate has been elected as the OSPF backup designated router.

There are at least 5 OSPF routers connected to the port4 network.

Two OSPF routers are down in the port4 network.

Question 22

An administrator has configured two FortiGate devices for an HA cluster. While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device. The administrator decides to enable the setting link-failed-signal to fix the problem.

Which statement about this setting is true?

Options:

It sends an ARP packet to all connected devices, indicating that the HA virtual MAC address is reachable through a new master after a failover.

It sends a link failed signal to all connected devices.

It disabled all the non-heartbeat interfaces in all HA members for two seconds after a failover.

It forces the former primary device to shut down all its non-heartbeat interfaces for one second, while the failover occurs.

Question 23

An administrator has been assigned the task of creating a set of firewall policies which must be evaluated before any custom policies defined within the policy packages of managed FortiGate devices, across all 25 ADOMSs in FortiManager.

How should the administrator accomplish this task?

Options:

Create a footer policy in the Global ADOM containing the firewall policies that must be evaluated first, and then assign this footer policy to all other ADOMs.

Create a header policy in the Global ADOM containing the firewall policies that must be evaluated first, and then assign this header policy to all other ADOMs.

Move the FortiGate devices into a single globally scoped ADOM, and merge policy packages, inserting the new firewall policies at the top.

Use a CLI script from the root ADOM on FortiManager to push these new policies to all FortiGate devices, through the FGFM tunnel.