Free Access Juniper JN0-363 New Release

In MPLS, multiple paths can be merged if they share the same egress router. In the given scenario, traffic from Network 1 to Network 3 and Network 4 can be engineered to follow the same label-switched path (LSP) within the MPLS network until they reach the last common point before diverging to their respective destinations.

As for R3 performing label operations, in a typical MPLS network, intermediate routers (like R3) perform label swapping. They replace the incoming label with a new label before forwarding the packet along the LSP. A label pop operation is typically performed by the egress router in the case of an ultimate hop pop (UHP), where it removes the MPLS label before delivering the packet to the final destination outside the MPLS domain.

References

• Juniper Networks Technical Documentation on MPLS
• Understanding MPLS Label Operations (Swap, Push, and Pop) - Juniper Networks

https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first-ospf/13684-12.html#anc13

Neighbors Stuck in Exstart/Exchange State The problem occurs most frequently when you attempt to run OSPF between a Cisco router and another vendor router. The problem occurs when the maximum transmission unit (MTU) settings for neighboring router interfaces do not match. If the router with the higher MTU sends a packet larger that the MTU set on the neighboring router, the neighbor router ignores the packet. When this problem occurs, the output of the show ip ospf neighbor command displays output similar to what is shown in this figure.

A mismatched Maximum Transmission Unit (MTU) setting on OSPF interfaces can cause routers to get stuck in the ExStart state. OSPF requires that both sides of a link have the same MTU to form a full adjacency.References:

• OSPF Troubleshooting, Juniper Networks Documentation
• MTU and OSPF, Juniper Networks Documentation

R2 can not forward IBGP learned routes to another IBGP neighbor correct

R3 will learn about Route X from R2 only. R1 is in a separate AS and Route X is advertised to R2 through eBGP. R2 will then advertise the route to R3 using iBGP. R3 cannot learn routes directly from another AS without having a direct eBGP session with that AS.References:

• BGP Route Propagation and Selection, Juniper Networks Documentation
• Understanding iBGP and eBGP Route Distribution, Juniper Networks Documentation

Wide metrics in IS-IS allow for a larger metric value than what is available with narrow metrics, which supports a maximum of 63. Wide metrics also enable an interface to advertise different metrics for Level 1 and Level 2, allowing for more flexible routing policies and greater scalability in large networks.References:

• IS-IS Wide Metrics, Juniper Networks Documentation
• Configuring IS-IS Wide Metrics, Juniper Networks Documentation