CompTIA XK0-005 Online Access

The following commands can help you confirm that the new RAID adapter has been recognized by the Linux system:

dmesg: This command displays the kernel messages, which can show the information about the newly detected hardware device. You can use dmesg | grep -i raid to filter the output for RAID-related messages.

lshw -class disk: This command lists the disk devices on the system, including the RAID controller and its model name. You can use lshw -class disk | grep -i raid to filter the output for RAID-related information1.

The other commands are not relevant for this purpose. For example:

rmmod: This command removes a module from the Linux kernel, which is not useful for detecting a new device.

ls -l /etc: This command lists the files and directories in the /etc directory, which is not related to hardware devices.

pvdisplay: This command displays the attributes of physical volumes, which are part of the logical volume management (LVM) system, not the RAID system.

rmdir /dev: This command removes an empty directory, which is not helpful for detecting a new device. Moreover, /dev is a special directory that contains device files, and should not be removed.

The issue is that the administrator did not set the default target to graphical.target. A target is a unit of systemd that groups together other units by a common purpose or state. The graphical.target is a target that starts the graphical user interface (GUI) along with other services. The administrator used the command systemct1 isolate graphical.target to switch to this target temporarily, but this does not change the default target that is activated at boot time. To make this change permanent, the administrator should have used the command systemct1 set-default graphical.target, which creates a symbolic link from /etc/systemd/system/default.target to /usr/lib/systemd/system/graphical.target.

The other options are not correct explanations for the issue. The administrator did reboot the server properly by using systemct1 reboot, which shuts down and restarts the system cleanly. The administrator did not need to set the default target to basic.target, which is a minimal target that only starts essential services. The administrator did not shut down the server improperly, which could have caused file system corruption or data loss, but not affect the default target. References: systemct1(1) - Linux manual page; How to Change Runlevels (targets) in SystemD

The error indicates that X11 forwarding is not enabled. X11 forwarding allows graphical applications to be displayed on a remote system over an SSH connection. Enabling X11 forwarding in /etc/ssh/ssh_config and restarting the SSH service ensures that the necessary configuration is applied, allowing the administrator to open graphical applications remotely.

The docker image tag test test:v1 command can be used to assign the v1 version to the image called test. This command creates a new tag for the existing image, without changing the original image. The docker image save test test:v1 command would save the image to a file, not assign a version. The docker image build test:vl command is invalid, as vl is not a valid version number. The docker image version test:v1 command does not exist. References: [CompTIA Linux+ (XK0-005) Certification Study Guide], Chapter 16: Virtualization and Cloud Technologies, page 500.