CompTIA SK0-005 Questions Answers

DLP, or Data Loss Prevention, is a type of security measure that aims to prevent unauthorized access, use, or transfer of sensitive data. DLP can be applied to various types of data, such as email, cloud storage, network traffic, or fileshares1. DLP for fileshares can help monitor and control who can access, modify, or share files on a network share2. By turning on DLP for the fileshare and letting it propagate for a week, the administrator can audit the permissions of the fileshare and see if there are any violations or anomalies in the access patterns. This can help the administrator identify and remediate any potential risks or compliance issues related to the fileshare2. The other options are incorrect because they are not directly related to DLP for fileshares. Managing the fileshare from an RDP session or from the fileshare itself are administrative tasks that do not require DLP. Auditing the access to the physical fileshare is a physical security measure that is not affected by DLP.

An incremental backup only backs up files that have changed since the last backup, whether it was a full or an incremental backup. Therefore, an incremental backup file may require another file to restore data, depending on the sequence of backups. A full backup backs up all files and does not require any other file to restore data. A snapshot is a point-in-time copy of data that does not depend on other files. A differential backup backs up files that have changed since the last full backup and does not require any other file to restore data.

A SD card is a type of flash memory card that can be used to store data and run applications. A SD card can be used to install a Type 1 hypervisor on a server, as it provides fast boot time, low power consumption, and high reliability. A Type 1 hypervisor runs directly on the underlying computer’s physical hardware, interacting directly with its CPU, memory, and physical storage. For this reason, Type 1 hypervisors are also referred to as bare-metal hypervisors. A Type 1 hypervisor takes the place of a host operating system and VM resources are scheduled directly to the hardware by the hypervisor123. A NAS drive (B) is a type of network-attached storage (NAS) device that provides shared access to files and data over a network. A NAS drive cannot be used to install a Type 1 hypervisor on a server, as it requires a network connection and a host operating system to function. A SATA drive © is a type of hard disk drive (HDD) or solid state drive (SSD) that uses the Serial ATA (SATA) interface to connect to a computer. A SATA drive can be used to install a Type 1 hypervisor on a server, but it may have some disadvantages compared to a SD card, such as slower boot time, higher power consumption, and lower reliability. A SAS drive (D) is a type of hard disk drive (HDD) or solid state drive (SSD) that uses the Serial Attached SCSI (SAS) interface to connect to a computer. A SAS drive can also be used to install a Type 1 hypervisor on a server, but it may have similar disadvantages as a SATA drive, and it may also be more expensive and less compatible than a SD card. References: 1 https://phoenixnap.com/kb/what-is-hypervisor-type-1-2  2 https://www.ibm. com/topics/hypervisors 3 https://www.redhat.com/en/topics/virtualization/what-is-a-hypervisor

The solution the administrator implemented extended runtime. Runtime is the amount of time that a UPS can provide backup power to a server in case of a power outage. By installing additional batteries in the UPS, the administrator increased the capacity and duration of the backup power, allowing the server more time to shut down properly.

References: CompTIA Server+ SK0-005 Certification Study Guide, Chapter 1, Lesson 1.4, Objective 1.4