Complete CWNA-109 CWNP Materials

Implementing Fast BSS Transition (FT) for roaming is likely to cause the least impact on the application layer throughput of an 802.11n client station in a 2.4 GHz HT BSS. FT is a feature that allows a client station to quickly switch from one AP to another within the same ESS (Extended Service Set) without having to re-authenticate and re-associate with each AP. This reduces the latency and packet loss that may occur during roaming, thus improving the user experience and maintaining the application layer throughput. FT is defined in the IEEE 802.11r amendment and is also known as Fast Roaming or Fast Secure Roaming. References: , Chapter 9, page 367; , Section 6.3

https://7signal.com/802-11ac-migration-part-2-whats-nobodys-telling-you-about-80mhz-and-160mhz-channel-bonding

The clients are all 802.11n STAs or lower is the likely cause of this behavior. If a WLAN with 100 802.11ac access points is configured to use 80 MHz channels, butonly 40 MHz communications are seen in a particular BSS, it means that the clients in that BSS do not support 80 MHz channels. This could be because they are using older standards, such as 802.11n or lower, that do not support 80 MHz channels. Alternatively, they could be using newer standards, such as 802.11ac or ax, but have their channel width settings limited to 40 MHz or lower due to device capabilities or configuration options. In either case, the AP will adapt to the client’s channel width and use only 40 MHz of the 80 MHz allocated bandwidth to communicate with them. This will reduce the potential throughput and efficiency of the WLAN. References: , Chapter 3, page 111; , Section 3.2

A POE device that requires 47 W of power should use the 802.3bt specification. This is because 802.3bt is the latest POE standard that supports up to 90 W of power delivery over four pairs of wires in an Ethernet cable. The previous POE standards, such as 802.3af and 802.3at, only support up to 15.4 W and 30 W of power delivery over two pairs of wires in an Ethernet cable, respectively. Therefore, they are not sufficient for powering a device that requires 47 W of power. The 802.11at specification does not exist; it is a typo or confusion with the 802.3at specification. References: CWNA-109 Study Guide, Chapter 8: Wireless LAN Access Points, page 2431

Shared Key Authentication is a security solution that was defined in the original 802.11 standard as an alternative to Open System Authentication, which does not provide any security at all. Shared Key Authentication uses WEP (Wired Equivalent Privacy) to encrypt and authenticate data frames between the client station and the AP. However, WEP has been proven to be extremely vulnerable to various attacks that can easily crack the encryption key and compromise the network security. Therefore, Shared Key Authentication is deprecated in the 802.11 standard and should never be used in any modern WLAN deployment . References: [CWNA-109 Study Guide], Chapter 10: Wireless LAN Security, page 401; [CWNA-109Study Guide], Chapter 10: Wireless LAN Security, page 391; [Wikipedia], Wired Equivalent Privacy.